Scribd
Upload
26 views

Process Control-IC

1. The document appears to be a mid-semester exam for a Process Control course taken at Atmiya Institute of Technology and Science in Rajkot, India. 2. It contains two questions with multiple parts asking students to explain concepts related to feedback control systems, control modes, and transfer functions. 3. Diagrams, graphs, and mathematical proofs are required to answer some of the questions fully.

Uploaded by

mrkhandhedia
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
26 views

Process Control-IC

1. The document appears to be a mid-semester exam for a Process Control course taken at Atmiya Institute of Technology and Science in Rajkot, India. 2. It contains two questions with multiple parts asking students to explain concepts related to feedback control systems, control modes, and transfer functions. 3. Diagrams, graphs, and mathematical proofs are required to answer some of the questions fully.

Uploaded by

mrkhandhedia
Copyright
© Attribution Non-Commercial (BY-NC)
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

Roll No: ______ Enrolment

No:______

GUJARAT TECHNOLOGICAL UNIVERSITY


ATMIYA INSTITUTE OF TECHNOLOGY AND SCIENCE, RAJKOT
MID-SEM EXAMINATION, MARCH– 2011
B. E. SEM. VI (IC)
Sub: Process Control

DATE: 16-03-2011 TIME: 11:15 AM to 12:45 PM


MARKS: 30

INSTRUCTIONS:

1. Attempt all the questions.


2. Figures to the right indicate full marks.
3. Assume suitable additional data, if required.

Q.1 (a Draw the generalized block diagram of feed back control system 4
) and derive transfer function for set point and disturbance change
(b Explain Floating control mode in detail 5
)
OR
(b Explain proportional control mode. Prove by graphs that as gain Kc 5
) increases, system may become unstable.

(c For the system having error as in figure, is applied to a proportional 6


) plus derivative controller, draw its controller output v/s time graph.
Kp=5, Kd= .5 sec.

OR
(c Prove: For a disturbance change of step input in Three tank system, 6
) proportional mode has offset error but integral mode does not
have.
GcGvGp = Kp/(Ts+1)3, Gd= Kd/(Ts+1)3, Gc= Kc (for Proportional)
and Gc= (Kc Ti)/s.
Q-2 (a Explain MIMO system. 4

1|Page
)

(b Explain the selection of Controlled and Manipulated variables from 5


) F/B control loop.
OR
(b Explain parallel structure of simplest system 5
)
(c Explain Non interacting series structure of simple system 6
)
OR
(c Following is two series ISOTHERMAL CSTR process. Derive the 6
) Transfer Function (CA2(s)/CA0(s)) of the following System

2|Page

You might also like