Scribd
Upload
278 views1 page

Readme For AMI BIOS

This document provides instructions for flashing a BIOS update file by booting from a DOS device. The instructions specify to save and extract the BIOS file, boot to a DOS prompt and run the AMI.BAT file with the filename, wait for flashing to complete without interrupting, reboot and press F1 and F9 in the BIOS setup screen, then F10 to save and exit. It notes that if the BIOS flash fails, the user manual may have recovery instructions or the motherboard can be sent to the RMA department for reprogramming.

Uploaded by

Dell Storage
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
278 views1 page

Readme For AMI BIOS

This document provides instructions for flashing a BIOS update file by booting from a DOS device. The instructions specify to save and extract the BIOS file, boot to a DOS prompt and run the AMI.BAT file with the filename, wait for flashing to complete without interrupting, reboot and press F1 and F9 in the BIOS setup screen, then F10 to save and exit. It notes that if the BIOS flash fails, the user manual may have recovery instructions or the motherboard can be sent to the RMA department for reprogramming.

Uploaded by

Dell Storage
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

================================================

FOR <filename>.zip
================================================

a). Save this file to your computer.


b). Extract the files to a DOS bootable device (such as a bootable USB s
tick, or CD).
c). Boot to a DOS prompt and type AMI.BAT filename.xxx.(example AMI.BAT
X8DT30.311)
d). Do not interrupt the process until the flashing is complete.
e). If the computer pauses, please wait until it starts to program.
f). Reboot the system by pressing "CTRL+ALT+DEL" .
g). Press "F1" to the BIOS screen when system reboot and shows the messa
ge "Press F1 to go to setup or press F2 to continue.
h). Press "F9" to "load the default" in the BIOS screen.
i). Press "F10" to "Save and Exit"

** If the BIOS flash failed, you can check the user's manual how to recover your
BIOS or contact our RMA dept. to have the bios chip reprogrammed.
This will require shipping the board to our RMA dept. for BIOS reprogramming.
The RMA dept's email address is [email protected]

You might also like