Scribd
Upload
316 views3 pages

Usb Adapter

This adapter allows connecting USB printers to older PCs through the parallel port. It has a DB25 female connector for the PC and a USB plug for the printer. No drivers are needed. It is compatible with USB 1.1 and 2.0 for printing functions only and is particularly suitable for older HP printers.

Uploaded by

hardcjo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
316 views3 pages

Usb Adapter

This adapter allows connecting USB printers to older PCs through the parallel port. It has a DB25 female connector for the PC and a USB plug for the printer. No drivers are needed. It is compatible with USB 1.1 and 2.0 for printing functions only and is particularly suitable for older HP printers.

Uploaded by

hardcjo
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 3

Parallel-USB-adapter reverse

"LPT to USB"

Key Features
Key Features
• allows you to connect a USB printer or
USB multifunction device to the parallel
• to use USB printers at parallel ports
port
(LPT)
• DB25 Female (computer end)
• LPT to USB cable
• USB plug type B (printer side)
• DB25 male (PC connection)
• No software required
• USB plug B (printer connection)
• Supplied with power supply
• no software or drivers required
• Cable length 1.8m
• With power supply
• cable length 1.8 meters
• USB 1.1 and USB 2.0 compatible
• recommended for HP printers
• only for printing function

• compatible USB 1.1 and USB 2.0


Description

Parallel-to-USB adapter: "LPT to USB"


Special adapter: The adapter is offered here is not an ordinary USB-to-parallel adapter, but a special type
of adapter REVERSE parallel-to-USB. Current printers usually have only a USB interface. With the
REVERSE adapter to connect a new USB printer to the old parallel port (LPT) of the PC.

Adaptation: The adapter is suitable for printers with USB 1.1 and USB 2.0. There are low-speed 1.5
Mbit / sec and supports Full-Speed 12 MBit / sec. For multi-function devices sole function PRINT is
supported.

No drivers needed: The driver installation is required. The LPT2USB adapter is therefore suitable for all
operating system.
Interface Protocols: unidirectional, bi-directional, bi-directional 1284.4
Supported Standards: SPP, ECP, IEEE1284, IEEE1284.4
Power supply: Input 10-240V, 50/60Hz, Output 5V / 100 mA. The set ended power supply must be
plugged, otherwise no power adapter for the electronics is available.
Bi-directional: Nibble Mode, Byte Mode, ECP Reverve, BECP reverse

Compatibility:
The parallel-
to-USB adapter
can be used
only for the
type of
functioning
PRINT.
Scanning, PC-
Fax software
and tool boxes
are not
supported.

The adapter is
particularly
suitable for
PCL or
PostScript
printer. The
use is
especially
recommended
for HP printers,
because the
adapter was
originally
designed
specifically for
Hewlett
Packard
products.
The adapter is
not compatible
with GDI
printers (eg
HP: "host
based printing"
or "LIDL" is
not supported,
for example,
Canon:
"CAPT" is not
supported).

You might also like