Scribd
Upload
3K views2 pages

Tutorial 6

The document discusses multiplexing techniques including frequency division multiplexing (FDM) and time division multiplexing (TDM). It provides examples of calculating bandwidth requirements for FDM, constructing output frames in a synchronous TDM system, and examples of the contents of output frames from multiplexers and demultiplexers in TDM systems.

Uploaded by

HaSnul AziRah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3K views2 pages

Tutorial 6

The document discusses multiplexing techniques including frequency division multiplexing (FDM) and time division multiplexing (TDM). It provides examples of calculating bandwidth requirements for FDM, constructing output frames in a synchronous TDM system, and examples of the contents of output frames from multiplexers and demultiplexers in TDM systems.

Uploaded by

HaSnul AziRah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ITT400 Data Communication and Network

Tutorial 6

1. Describe the goals of multiplexing.


2. Distinguish between a link and a channel in multiplexing.
3. Assume that a voice channel occupies a bandwidth of 4kHz. We need to multiplex 10
voice channels with guard bands of 500 Hz using FDM. Calculate the required bandwidth.
4. What are the three major multiplexing techniques?
5. How does TDM combine multiple signals into one?
6. We need to use synchronous TDM and combine 20 digital sources, earch of 100 Kbps.
Each output slot carries 1 bit from each digital source, but one extra bit is added to each
frame for synchronization. Find
a) Size of an output frame in bits
b) Output frame rate
c) Duration of an output frame
d) Output data rate
e) Efficiency of the system (ratio of useful bits to the total bits)

7. Repeat question 11 if each output slot carries 2 bits from each source.
8. Show the contents of the five output frames for a synchronous TDM multiplexer that
combine four sources sending the following characters. Note that the characters are sent
in the same order that they are typed. The third source is silent.
a) a) Source 1 message: HELLO
b) b) Source 2 message: HI
c) c) Source 3 message:
d) d) Source 4 message: BYE

9. Figure below shows a multiplexer in a synchronous TDM system. Each output slot is only
10 bits long (3bits taken from each input plus 1 framing bit). What is the output stream?
The bits arrive at the multiplexer as shown by the arrows.
10. Figure below shows a demultiplexer in a synchronous TDM. If the input slot is 16 bits long
(no framing bits), what is the bit stream in each output? The bits arrive at the
demultiplexer as shown by the arrows.

You might also like