Scribd
Upload
185 views1 page

K 182

Kit 182A is an ICSP FLASH USB PIC programmer kit that is identical to Kit 128 except without the ZIF socket. The firmware hex file is the same as Kit 128 and works with the MicroPro software available from the provided download link. The kit can be used to program PIC16F628A chips by connecting VPP, GND, VCC, CLK, DAT pins as shown in the documentation photos.

Uploaded by

Manasvi Sihag
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
185 views1 page

K 182

Kit 182A is an ICSP FLASH USB PIC programmer kit that is identical to Kit 128 except without the ZIF socket. The firmware hex file is the same as Kit 128 and works with the MicroPro software available from the provided download link. The kit can be used to program PIC16F628A chips by connecting VPP, GND, VCC, CLK, DAT pins as shown in the documentation photos.

Uploaded by

Manasvi Sihag
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

KIT 182A.

ICSP FLASH USB PIC PROGRAMMER


This documentation was written September 6, 2004. The kit uses a USB ‘B’ female connector.

Kit 182A is Kit 128 assembled but without the ZIF Firmware. The firmware chip supplied with this kit will
socket (and 2 resistors.) The firmware hex file is the same run with MicroPro.exe from diypack22zip. Only if you
as Kit 128. Download the User Interface from are upgrading from an earlier diypackxx do you need to
reprogram the firmware with the supplied diyk128.hex
http://www.crowcroft.net/kitsrus/diypack22.zip file.

Run setup.exe. The program will unpack to Software and Firmware Upgrades. New PICs are being
C:\diypgmrp. You will find k128.pdf. Please print it out released almost every month. Keep a watch at
and read in conjunction with this documentation. Read the http://www.kitsrus.com/upuc.html
readme.txt. Remember this kit, kit 182A is the same as kit
128 but without the ZIF socket. NOTE: if you log onto this site and find a later version of
diypack.zip then make sure you still download
diypack22.zip and not the latest version. After you have
the kit working then you can download the latest version,
upgrade the firmware and run with the latest
MicroPro.exe. You can upgrade by buying and
programming a second 628-20/P PIC, or if you have
access to a second PIC programmer and reprogram the
existing 628 in it.

PIC16F628A-PI. Hex files in diypack22 can be


programmed into the newer 16F628A.

Here is a photo of how we setup Kit 182A to program a


628A chip. VPP to pin 4, GND to pin 5, VCC to pin 14,
CLK to pin 12, DAT to pin 13. Pin 10 to GND with a
10K resistor. www.kitsrus.com/jpg/k182_6.jpg

Get the color photo at www.kitsrus.com/jpg/k182_5.jpg

Problems. Email me at [email protected]

Here is a photo of the other side. Get the color photo at


http://www.kitsrus.com/jpg/k182_2.jpg

You might also like