Scribd
Upload
599 views1 page

Profile Reed Specification

This document provides specifications for a Toyota Jat-710 air-jet weaving machine, including that it has a reed height of 112mm and length of 1653mm, can operate between 900-950 RPM, and is capable of weaving various warp and weft counts of polyester/viscose and polyester/cotton blends at densities between 48-56 picks per inch. The machine is equipped with an air tucker to produce fabric widths of 65 inches.

Uploaded by

dineshkeswani
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
599 views1 page

Profile Reed Specification

This document provides specifications for a Toyota Jat-710 air-jet weaving machine, including that it has a reed height of 112mm and length of 1653mm, can operate between 900-950 RPM, and is capable of weaving various warp and weft counts of polyester/viscose and polyester/cotton blends at densities between 48-56 picks per inch. The machine is equipped with an air tucker to produce fabric widths of 65 inches.

Uploaded by

dineshkeswani
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as XLSX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Toyota Jat-710 Air-jet Profile reed Remark

Weaving Machine type Air-jet


Weaving Machine make Toyota Jat-710
Machine RPM Range 900 to 950
Warp count Ne 2/30 PV (65:35), and 15 PC (65:35)
Weft Count Ne 2/30 PV (65:35), and 15 PC (65:35)
EPI 50 (2 end/dent)and 75 (3 ends/dent)
PPI 48, 50 and 56
DPI 25
quntity ( pcs) 10
Reed Height (mm) 112
Reed Length (mm) 1653 the on loom fabric width will be 65" with air tuck in selvedge
Top channel height (mm) 12
Top channel width (mm) 8
Bottom channel height (mm) 18
Bottom channel thickness (mm) 8
Reed Type Profile
Entry at LHS Conical
DLC Dent ( unprofile dent) at LHS up to 10 mm Yes
Profile height up to lower leaf (mm) 49
Profile height up to Upper leaf (mm) 56
Air flow rate as per weft count and blend
Dent Thick ness, width & air-space as per weft count and blend

Machine attached with air tucker +


Remark

detail drawing of reed is attached


for ease of understanding the
requirement, even if any further
clarification is required please do
communicate

PV Polyster viscose blend


PC Polyster cotton blend

You might also like