Chemistry Investigatory Project On Extration of Oil From Seeds
Chemistry Investigatory Project On Extration of Oil From Seeds
Chemistry Investigatory Project On Extration of Oil From Seeds
1
Acknowledgement
I feel proud to present my investigatory project in chemistry on
the “To extract essential oil Present in Saunf(aniseed)”
This project would not have been feasible without the proper
rigorous guidance of chemistry teacher Mr.R.N.Chauhan who
guided me throughout this project in every possible way. An
investigatory project involves various difficult lab experiments,
which have to obtain the observations and conclude the reports
on a meaningful note. These experiments are very critical and
in the case of failure may result in disastrous consequences.
Thereby, I would like to thanks both Mr.R.N.Chauhan and lab
assistant Mr.Damoder for guiding me on a systematic basis
and ensuring that in completed all my experiments with
ease.Rigorous hard work has put in this project to ensure that it
proves to be the best. I hope that it proves to be the best. I hope
that this project will prove to be a breeding ground for the next
generation of students and will guide them in every possible
way.
2
AIM
To extract essential oil
Present in Saunf (aniseed)
3
INTRODUCTION
We are all familiar with the pleasant odours coming out from flowers,
spices and many trees. The essence or aromas of plants are due to volatile
oils present in them. These smelling volatile oils present in plants are called
essential oils. Cinnamon, clove, cumin, eucalyptus, garlic, jasmine,
peppermint, rose, sandalwood, spearmint, thyme, wintergreen are a few
familiar examples of valuable essential oils. The term “essential oils”
literally means “oils derived from the essence” of plants. Essential oils are
mainly used for their pleasant odours and flavors in perfumes and as
flavoring agents in foods. Some are used in medicines (e.g., camphor,
wintergreen, eucalyptus) others as insect repellants (e.g., citronella).
Chemically essential oils are composed of complex mixtures of ester,
alcohols, phenols, aldehydes, ketones and hydrocarbons. They are
essentially non-polar compounds and are thus soluble in non-polar solvents
such as petroleum ether, benzene etc. Essential oils may occur in all parts
of the plant, but they are often concentrated in the seeds or flowers. They
are obtained from the plants by the process of steam distillation and
extraction. The technique of steam distillation permits the separation of
volatile components from non-volatile materials without raising the
temperature of the distillation above 100°C. Thus steam distillation
reduces the risk of decomposition of essential oils.
4
ANISEED ESSENTIAL OIL
Aniseed Plant
5
Aniseed Essential Oil
6
Aim:-
To extract essential oil Present in Saunf(aniseed)
REQUIREMENTS:-
Steam generator (Copper Vessel), round bottom flask (500ml), conical flask,
condenser, glass tubes, iron stand, sand bath, separatory funnel, tripod stands,
burners, Ajwain(Carum), Petroleum ether(60-80°C),Saunf(Aniseed) .
PROCEDURE:-
1. Set the apparatus as shown in the picture of Experimental Setup. The apparatus
Consists of a steam generator connected to the round bottom flask through a
glass Inlet tube. The flask is connected to a water condenser through a glass
outlet tube. Condenser is further attached to a receiver through an adaptor.
2. Take about 750 ml of water in the steam generator and start heating to
produce steam.
3. In the round bottom flask take about 75 gm of crushed saunf.
4. A vigorous current of steam from steam generator is passed through the round
bottom flask.
5. A part of the steam condenses in the round bottom flask. As more and more
steam is passed, the steam volatile components of saunf pass through the
condenser along with steam. These contents on condensation are collected in the
receiver.
6. The contents in the round bottom flask may be heated by a bunsen burner to
prevent excessive condensation of steam.
7. The process of steam distillation is continued for about half an hour.
8. Transfer the distillate to a separating funnel and extract with 20 ml portions of
Petroleum ether 3 times.
9. Combine the petroleum ether extracts in a 250 ml conical flask and dry it with
the help of anhydrous sodium sulphate.
10. Remove the solvent from the dried filtrate by careful distillation in a water
bath. The essential oil is left behind in the distillation flask.
11. Find the weight of the extracted essential oil. Note the color,odour and weight.
7
OBSERVATIONS:-
8
Experiment setup
9