Scribd
Upload
157 views2 pages

Lab 3

This document provides instructions for an experiment on designing a NOR gate using L-edit software. The objectives are to use L-edit to draw the stick diagram and CMOS layout of a NOR gate. Students are instructed to draw the NOR gate with specified PMOS and NMOS widths and lengths, save the file, and run design rule checking to check for errors. The overall goal is for students to practice using L-edit software to design basic CMOS logic gates.

Uploaded by

Hilman Abdullah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
157 views2 pages

Lab 3

This document provides instructions for an experiment on designing a NOR gate using L-edit software. The objectives are to use L-edit to draw the stick diagram and CMOS layout of a NOR gate. Students are instructed to draw the NOR gate with specified PMOS and NMOS widths and lengths, save the file, and run design rule checking to check for errors. The overall goal is for students to practice using L-edit software to design basic CMOS logic gates.

Uploaded by

Hilman Abdullah
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

POLITEKNIK TUANKU SYED SIRAJUDDIN

E5163 – REKABENTER LITAR BERSEPADU

EXPERIMENT 3: NOR GATE


EXPERIMENT 3 :

TOPIC : NOR GATE

OBJECTIVE : At the end of this session, the students should be able:


- to use L-edit software.
- to draw stick diagram
- to draw CMOS layout used NOR gate.
-
EQUIPMENT : 1. L-Edit software
2. Multi Colour Pen (GREEN, PURPLE, BLUE,
BLACK, RED)

PROCEDURE 1. Draw a NOR gate with below specification. Split to 1 leg.

Pmos - 20 λ
Nmos - 14 λ

2. After the drawing is complete, Save your file : File>Save give


a file name.

3. Check your layout using Design Rule Check (DRC). Follow


this step :

Tools>DRC and click OK for run a design rule checker which


determines whether a design obeys a specific set of rules. Design
rule violations can be reported directly on the layout, in a text file
or both. If you get a message ‘No DRC errors found’ click OK.

You might also like