Scribd
Upload
167 views1 page

SJ To Dyonics Power Interface

The document is a circuit diagram showing power and signal connections for a small joint MDU. It includes a voltage regulator supplying 2.8V and 5V rails from an 8.3V input. RS485 differential signal pairs on connectors J3 and J4 are connected to an isolation chip and ADC for telemetry while maintaining common mode voltage isolation between 3-5V and ground.

Uploaded by

m_brodsky
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
167 views1 page

SJ To Dyonics Power Interface

The document is a circuit diagram showing power and signal connections for a small joint MDU. It includes a voltage regulator supplying 2.8V and 5V rails from an 8.3V input. RS485 differential signal pairs on connectors J3 and J4 are connected to an isolation chip and ADC for telemetry while maintaining common mode voltage isolation between 3-5V and ground.

Uploaded by

m_brodsky
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

5 4 3 2 1

D D

+12V

ISO4
Max allowed
on B/Z and A/Y
per specification
is -9V to +13V
R6
2.8V 1K
C 8.3V C

+5V
J3 P6-1 +5V
+5V 1 1
U5
1 8 D13
RO VCC RS485-B/Z Logic 3 R16
2 7 R5
/RE B/Z 0.3V 10K
3 6 100
DE A/Y To ADC 5
4 DI GND 5 J4 P6-14
R8
ISL83072EIUZA 1 1

1K
RS485-A/Y Analog 2 D14
Small Joint MDU C24
B B
0.1uF
I R5 = 3 mA
8.0V
P R5 = 900 uW

Dyonics Power Control Unit

Note:
Signals are the same DC values with MDU running or not.
Minimum noise when running.

A A

5 4 3 2 1

You might also like