Scribd Logo
Upload

Welcome to Scribd!

  • 28 views

    Stringing On Beading Cable

    Uploaded by

    Lazarus Astlan

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd

    Stringing On Beading Cable

    Uploaded by

    Lazarus Astlan
    28 views1 page

    Original Title

    Stringing on Beading Cable

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    28 views1 page

    Stringing On Beading Cable

    Uploaded by

    Lazarus Astlan

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 1

    Techniques for stringing

    with beading cable

    1. Cut wire cable 4” longer than desired necklace or bracelet length. String a crimp bead onto one end of
    the cable and loop back through crimp bead. Try to tuck excess cable inside your end beads, otherwise
    trim neatly with flush cutters. Flatten crimp bead with standard round- or- flat-nose pliers. Use jump
    ring to attach one end of your clasp to cable.

    TIP: When opening and closing jump rings, twist sideways instead
    of “ovalling” them. This keeps their shape better, which makes
    them easier to close all the way. (As shown on the left.) To
    prevent marks on the ring use non-serrated flat-nose pliers.

    2. String desired pattern.

    3. Add final crimp bead; loop cable back through your crimp like in step 1. Tuck excess cable inside end
    beads, otherwise trim neatly with flush cutters. Flatten crimp bead and attach other end of the clasp
    with a jump ring.

    4. Some designs may require stringing the beads before finishing the cable ends. We recommend using
    Bead Stoppers™ (#69-144-06 and -16) to secure unfinished ends. When you have finished follow steps
    1 and 3.
    ______________________________________________________________________________________

    Variations:
    a. Crimping pliers: To make a nice rounded crimp bead, use the
    innermost section (1) of the pliers to crimp. Face crimp outward
    (as shown in example below) and use the outer section (2) of the
    pliers to round the bead.

    b. Crimp covers: Cover flattened crimps with a crimp cover. Make sure there is
    enough space around your crimp bead. Use section 2 (see picture above) of
    the crimping pliers to gently secure the cover over the bead.

    c. Bullion: Cut two pieces in precise equal lengths (approx. ½-¾”),


    add one crimp tube and one piece of bullion to the end of wire cable.
    Loop the cable through one portion of clasp and back through the crimp
    tube. Pull gently until the bullion is flush against the crimp and crimp
    closed.

    d. Wire protectors: Guard wire cable from excessive wear with wire protectors.
    These are used the same way as bullion.

    G:\TEXT\Example jewelry docs\Designer Tip sheets\Techniques\Stringing on beading cable.doc

    You might also like