Scribd
Upload
50 views2 pages

Sizzix Bigz XL Die - Twist Cube, (Pop-Up) by Karen Burniston

Die-cut, fold and add a strong adhesive as shown. Attach the bottom of the cube to your card with a brad and place adhesive on each of the four side tabs. Adhere the top piece to the sides and front, making sure the rib / hole is oriented diagonally across from the one at the bottom.

Uploaded by

Christelle Joy Eusebio
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
50 views2 pages

Sizzix Bigz XL Die - Twist Cube, (Pop-Up) by Karen Burniston

Die-cut, fold and add a strong adhesive as shown. Attach the bottom of the cube to your card with a brad and place adhesive on each of the four side tabs. Adhere the top piece to the sides and front, making sure the rib / hole is oriented diagonally across from the one at the bottom.

Uploaded by

Christelle Joy Eusebio
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

656739 Sizzix® Bigz™ XL Die – Twist Cube, (Pop-Up) by Karen Burniston

1. Die-cut, fold and add a strong adhesive 2. Create the ribs for the top and bottom
as shown. pieces as shown. Attach a no. 16 rubber
band to one of the pieces. This becomes
the bottom.

3. Add the three side pieces of the Cube 4. Cut away the two side tabs on what
by attaching one of the long flaps of each will become the front of the Cube.
to the underside of the bottom square.

5. Attach the bottom of the Cube to your 6. Adhere the sides to the front.
card with a brad and place adhesive on
each of the four side tabs.
656739 Sizzix® Bigz™ XL Die – Twist Cube, (Pop-Up) by Karen Burniston

7. Create a handle for the top of the Cube 8. Adhere the top piece to the sides and
by running a loop of ribbon through the front, making sure the rib/hole is oriented
hole and taping the ends. Do not knot the diagonally across from the one at the
end of the ribbon to keep it from slipping bottom, as shown. Stretch the rubber
through; it will not close flat. band between the top and bottom. Once
the rubber band is in place, you can
adhere the two flaps to their
corresponding side tabs.

9. Collapse the Cube by holding the 10. You may use the die to cut and score
bottom of the cube with one hand while your photos or images before placing
twisting the top with the other hand. If it them on the Cube. Note that all of the
does not collapse easily, you are twisting sides can be done in two pieces except for
it the wrong direction. the back, which needs to be done in four.

You might also like