CCNP Switch CH 1
CCNP Switch CH 1
CCNP Switch CH 1
01:44:13
Time Remaining:
QoS marking
software-based forwarding
4 During an evaluation of the currently installed network, the IT staff performs a gap analysis to determine whether the existing netwo
infrastructure can support certain new features. At which stage of the Cisco Lifecycle Services approach does this activity occur?
prepare phase
plan phase
design phase
implement phase
operate phase
optimize phase
Refer to the exhibit. Given the traditional hierarchical design model, which set of features correctly identifies the modules of an
enterprise network?
1. Multilayer
2. Edge
3. Security
4. Internet Gateway
1. Workgroup Switch
2. PSTN
3. Connectivity
4. Telecommuter Gateway
1. VoIP and Multilayer
2. PSTN Edge
3. Firewall
4. Home Branch
1. Workgroup and VoIP
2. Core
3. Internet Backbone
4. Telecommuter Edge
1. Building Access and Distribution
2. Internet Connectivity
3. Edge Distribution
4. Remote Access and VPN
1. Campus Edge
2. WAN Services
3. Core Security
4. PSTN Edge
Close Window
Assessment System
01:30:18
Time Remaining:
6 What two traffic types must be included when calculating the bandwidth requirements to support a voice stream in an IP telephony
network? (Choose two.)
voice queues
routing updates
7 What type of specialized memory is used to facilitate high performance switching in Cisco multilayer switches?
content-addressable memory (CAM)
8 Which Catalyst 6500 switch component integrates on individual line modules as well as on the supervisor engine?
CPU
Flash
ASIC
NVRAM
9 Which phase of the Cisco Lifecycle Services strategy may prompt a network redesign if too many network problems and errors arise
the network?
prepare
plan
design
implement
operate
optimize
Close Window
Assessment System
01:12:58
Time Remaining:
12 A network designer must provide a rationale to a customer for a design that will move an enterprise from a flat network topology to a
hierarchical network topology. Which two features of the hierarchical design make it the better choice? (Choose two.)
reduced cost
scalability
higher availability
13 A user needs to access a file server that is located in another department. Which layer of the Cisco Hierarchical Network Model will
process the traffic first?
access
core
distribution
control
14 What are the responsibilities of devices that are located at the core layer of the hierarchical design model? (Choose two.)
access list filtering
packet manipulation
15 Which family of Cisco switches supports Fibre Channel over Ethernet (FCoE)?
Catalyst 4948G
Catalyst 4500
Catalyst 6500
Nexus 5000
Close Window
Assessment System
00:55:15
Time Remaining:
Which two types of devices from the list would be appropriate to use at the access layer to provide end-user connectivity? (Choose
Catalyst 4503 switches
17 Which portion of the enterprise network provides access to network communication services for the end users and devices that are
spread over a single geographic location?
enterprise edge
campus module
WAN module
Internet edge
data center
Catalyst 6500
Nexus 5000
Nexus 7000
Catalyst 2000
Nexus 7000
Catalyst 4500
20 Which protocol is required for Cisco Express Forwarding to be able to successfully forward packets on a multilayer switch?
Cisco Discovery Protocol