Scribd
Upload
39 views

Quick Installation Guide

The document provides instructions for installing and using a Microchip PIC JDM Programmer. It outlines the steps to install the hardware by connecting cables from the programmer to the computer's serial port. It then details installing the software by extracting files to the hard drive and selecting the correct hardware and COM port settings. Finally, it notes the programmer settings needed for different types of PIC microcontrollers and serial EEPROMs.

Uploaded by

Eduardo Mendoza O
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views

Quick Installation Guide

The document provides instructions for installing and using a Microchip PIC JDM Programmer. It outlines the steps to install the hardware by connecting cables from the programmer to the computer's serial port. It then details installing the software by extracting files to the hard drive and selecting the correct hardware and COM port settings. Finally, it notes the programmer settings needed for different types of PIC microcontrollers and serial EEPROMs.

Uploaded by

Eduardo Mendoza O
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Microchip PIC JDM Programmer

Quick User Guide 1.0

1. Hardware Installation
1.1 Turn Off the PC
1.2 Connect the DB9 RS-232 serial cable Female connector to the PC’s RS-232
serial port.
1.3 Connect the DB9 RS-232 serial cable Male connector to the JDM
programmer.
1.4 Turn On the PC
(Please don’t use the NULL modem cable, it doesn’t work with this
programmer)

2. Software Installation
2.1 Copy the WinPIC800.zip from the CD or Floppy Disk into your Hard Disk
2.2 Unzip the “WinPIC800.zip”, all unzipped files should be placed in the same
directory or folder
2.3 Double click the “winpic800.exe” in the directory or folder, then you will see
the following screen:
2.4 Click Settings Æ Hardware

Select the “eTekronics-JDM” in the Hardware box, and the “COM” port in the
COM port box. After the selection, click the “Save” button to save the settings.
Then click the “Apply edits” to apply the settings.
2.5 Now you can start to program your PICs.

3. Programmer Settings for 8,18,28,40-PIN PIC and 24Cxx serial EEPROMs


3.1 8-PIN, 18-PIN PICs and 24Cxx serial EEPROMs
3.2 28-PIN and 40-PIN PICs

You might also like