Scribd
Upload
467 views1 page

Hidrostatic Bailer

This document provides information about two types of bailers used to clean tools during wireline operations: the hydrostatic bailer and sand pump bailer. The hydrostatic bailer uses fluid pressure to clean sand or debris from around fishing necks. The sand pump bailer is used when a sand bridge is encountered and pulls sand into a cylinder to remove it. Engineering data is provided for different sizes of each bailer, including dimensions and part numbers.

Uploaded by

spavoning
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
467 views1 page

Hidrostatic Bailer

This document provides information about two types of bailers used to clean tools during wireline operations: the hydrostatic bailer and sand pump bailer. The hydrostatic bailer uses fluid pressure to clean sand or debris from around fishing necks. The sand pump bailer is used when a sand bridge is encountered and pulls sand into a cylinder to remove it. Engineering data is provided for different sizes of each bailer, including dimensions and part numbers.

Uploaded by

spavoning
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

PARVEEN

Wireline Pressure Control Equipment & Tool String

‘HB’ HYDROSTATIC BAILER

PARVEEN Hydrostatic Bailer is used to clean off sand or foreign materials from around a
fishing neck of tools. Hydrostatic Bailer is used in situation where Pump Type Bailer are
not effective.

Engineering Data for Hydrostatic Bailer


SIZE PART NO. F/N O.D. THREAD CONNECTION GUIDE SHOE GUIDE SHOE
(IN.) (IN.) PIN (IN. - TPI) O.D.(IN.)* PART NO.
1.3/8 181411 1.187 15/16 - 10 UN 1.375 181411 - 13
1.750 181721 - 17
1.3/4 181721 1.375 15/16 - 10 UN 2.156 181721 - 21
2.687 181721 - 26

* Guide Shoe O.D. is the Max. Bailer Assembly O.D. Unless a specified O.D. is requested.
The smallest O.D. Guide Shoe is supplied.

‘SAB’ SAND PUMP BAILER


PARVEEN Sand Pump Bailer are used when a sand bridge is encountered during
operations. The bailer pulls sand into cylinder, to remove sand bridge. Bailer are available
in 3 types :

1. W/ Flat Bottom : For easy bailing of sand.


2. W/ Angled Bottom : For bailing hard packed sand
3. W/ Flapper Bottom : For bailing metallic particles which can not pass thru
ball & seat

Engineering Data for Sand Pump Bailer


SIZE PART NO. F/N O.D. THREAD CONNECTION GUIDE SHOE GUIDE SHOE
(IN.) (IN.) PIN (IN. - TPI) O.D.(IN.)* PART NO.
1.1/4 581211 1.187 15/16 - 10 UN 1.250 581211-12
1.437 581211-14
HYDROSTATIC 1.5/8 581611 1.187 15/16 - 10 UN 1.850 581611-18
BAILER 2.125 581611-21
2.500 581611-25
2.687 581611-26
3.500 581611-35
3.750 581611-37

*Guide Shoe O.D. is the Max. Bailer Assembly O.D. Unless a specified O.D. is requested.
The smallest O.D. Guide Shoe is supplied.
SAND PUMP
BAILER

You might also like