Scribd
Upload
64 views2 pages

LS882C 10

1. The document provides step-by-step instructions to disassemble a display. It involves removing the tilt/swivel, front cabinet, inverter wire shield, back cover, inverter shield, rear shield, and main total assembly. 2. Key steps include removing screws and latches, disconnecting connectors, and detaching various shields, covers, and the main assembly from the display. 3. Photographs illustrate the component locations and labeling of screws/connectors to remove at each step.

Uploaded by

cinematic3006
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
64 views2 pages

LS882C 10

1. The document provides step-by-step instructions to disassemble a display. It involves removing the tilt/swivel, front cabinet, inverter wire shield, back cover, inverter shield, rear shield, and main total assembly. 2. Key steps include removing screws and latches, disconnecting connectors, and detaching various shields, covers, and the main assembly from the display. 3. Photographs illustrate the component locations and labeling of screws/connectors to remove at each step.

Uploaded by

cinematic3006
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

DISASSEMBLY

1. TILT/SWIVEL REMOVAL 3. INVERTER WIRE SHIELD & BACK COVER


1) Remove Hinge Cover. REMOVAL
(Push the tilt cover both side). 1) Remove four screws (a).
2) Remove two screws (a). 2) Remove two Inverter Wire Shield.
3) Remove the Tilt/swivel. 3) Remove four screws (b).
4) Remove the Back Cover.

(a)
Inverter Wire
Shield (a)

(a)
(a)

(b)

2. FRONT CABINET REMOVAL


1) Remove two screws (a).
2) Release ten latches (b).
3) Remove the Front Cabinet.

Back Cover
Front Cabinet

(b)
(b)

(b)

(b)

(a)

- 11 -
4. INVERTER SHIELD & REAR SHIELD REMOVAL 5. MAIN TOTAL ASS’Y REMOVAL
1) Remove sponge (a). 1) Disconnect CN2, CN3, CN4 and CN5.
2) Remove two screws (b). 2) Remove five screws (a).
3) Remove the Inverter Shield. 3) Remove two Aluminium Tape (b).
4) Remove six screws (c). 4) Disconnect J805.
5) Remove the Rear Frame. 5) Remove Aluminium Tape (c).
6) Disconnect FPC Cable, Module Connector and
Control PCB Connector.
7) Remove Main Total Ass’y and Inverter PCB
Ass’y.

(b)

Inverter Shield

(c)
(c) (a)

(a)
(c)
Module Connector

(b)
(a) FPC Cable

Control PCB Connector


Rear Frame J805
(b) (c)
(a)

CN5
CN4

CN3
CN2

- 12 -

You might also like