Scribd
Upload
39 views1 page

Analog Solutions 01

The document discusses how to display measured data from a displacement sensor in either millimeters or inches using an LK Series sensor and KL controller unit. The KL unit can be configured through communication settings to receive analog input from the LK sensor and display the output in different units by multiplying and dividing the input voltage by conversion factors. Ladder logic is used to calculate and store the measured values in either mm or inches based on the configured display unit.

Uploaded by

phild2na2
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
39 views1 page

Analog Solutions 01

The document discusses how to display measured data from a displacement sensor in either millimeters or inches using an LK Series sensor and KL controller unit. The KL unit can be configured through communication settings to receive analog input from the LK sensor and display the output in different units by multiplying and dividing the input voltage by conversion factors. Ladder logic is used to calculate and store the measured values in either mm or inches based on the configured display unit.

Uploaded by

phild2na2
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Top Back Contact Us

How to display measured data in millimeters or


inches
The analog data output from the LK Series displacement sensor can be displayed in either millimeters or inches.

[System configuration]

Display in millimeters
(5.000 mm)

LK Series (Head) Switching

Analog
input Display in inches
KL (19.70 inch)

Note: LK controller is not shown


in the drawing.

[Communication settings for the KL unit]


KL-N 10V KL-4AD KL-2D A
1st address of send dat a 00H – –
N umber of send addresses 00H – –
1st address of receive dat a 00H – –
N umber of receive addresses 08H – –
Address f or KL-4AD – 00H –
Address f or KL-2D A – – –
FIN AL swit ch S et t ing OFF ON –
KL-4AD Range – +/-10V –

[Description of ladder diagram]


2008 KL-N10V Communication setup 2700 2701 2702 2704 2705 2706
( RES) ( SET ) ( SET ) ( SET ) ( RES) ( SET )
$0000 $0000 $0000 $0008
DW DW DW DW
DM1800 DM1801 DM1802 DM1803
2007 2700
( SET )

Calculates the input voltage value from KL-4AD


2002 DM1600 #00025 #00010 DM0000
LDA MUL DIV STA

Display in "mm"
2002 DM0000 DM0001
LDA STA

Display in "inch"
2002 DM0000 #00197 #05000 DM0002
LDA MUL DIV STA

You might also like