DI12

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

DI–572

DIAGNOSTICS – ANTI–LOCK BRAKE SYSTEM


DIB1B–01

DTC C1249 / 49 Stop Light Switch Circuit

CIRCUIT DESCRIPTION

DTC No. Detection Item Trouble Area


 Stop light switch
This stop light switch senses whether the brake pedal is de-
C1249 / 49  Skid control ECU
pressed or released, and sends the signal to the ECU.
 Wire harness

WIRING DIAGRAM
S5
Stop Light Switch
G–W 2 1 G–W

J/B No.3 Brake Actuator with ECU


2 1F 7 3F
G–W
J/B To Shift Lock (A/T) 10 4 10
3F G–W A22 STP
STOP

No.1 Control Relay 3F


H8
To Cruise
High Mount G–W 5 6
Control ECU 3F 3F
Stop Light
1 9 To Engine
W–B 2 1
2 1K IG1 G–W 3F ECM
G–W
2 1A 8 3F
B–R G–W
J/B No.1 R6
BN7 8
Stop Light LH
8 1J 4
21 3
W–B W–B W–B G–W
From BN7
Battery
W–B G–W
IG W–B
6

4
3
R7
Stop Light RH F17538

INSPECTION PROCEDURE

1 Check operation of stop light.

CHECK:
Check that stop light lights up when brake pedal is depressed and lights off when brake pedal is released.

NG Repair stop light circuit (See page BE–2).

OK

2003 TOYOTA TACOMA (RM1002U)

Author: Date: 834


DI–573
DIAGNOSTICS – ANTI–LOCK BRAKE SYSTEM

2 Check voltage between terminal STP of skid control ECU and body ground.

PREPARATION:
Disconnect skid control ECU connector.
CHECK:
STP (+) Measure voltage between terminal STP (10) of skid control
ECU harness side connector and body ground when brake
pedal is depressed.
(–)
OK:
Voltage: 8 – 14 V
F17531

OK Proceed to next circuit inspection shown on


problem symptoms table (See page DI–545).

NG

3 Check for open in harness and connector between skid control ECU and stop
light switch (See page IN–28).

NG Repair or replace harness or connector.

OK

Check and replace brake actuator ASSY.

2003 TOYOTA TACOMA (RM1002U)

Author: Date: 835

You might also like