Scribd Logo
Upload

Welcome to Scribd!

  • 23 views

    MR313CABRIOLET6

    Uploaded by

    Kaloyan Dobrev

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd

    MR313CABRIOLET6

    Uploaded by

    Kaloyan Dobrev
    23 views3 pages

    Copyright

    © Attribution Non-Commercial (BY-NC)

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    23 views3 pages

    MR313CABRIOLET6

    Uploaded by

    Kaloyan Dobrev

    Copyright:

    Attribution Non-Commercial (BY-NC)
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 3

    Sealing and soundproofing

    BODY SEALING

    77 11 192 972 FEBRUARY 1997 Edition Anglaise

    "The repair methods given by the manufacturer in this document are based on the All copyrights reserved by Renault.
    technical specifications current when it was prepared.
    Copying or translating, in part or in full, of this document or use of the service part
    The methods may be modified as a result of changes by the manufacturer in the reference numbering system is forbidden without the prior written authority of
    production of the various component units and accessories from which his vehicles Renault.
    are constructed".

    C Renault 1997
    Sealing and
    soundproofing

    Contents
    Pages

    64 WINDOW SEALING
    Windscreen pillar seal 64-1
    BODY SEALING
    Windscreen pillar seal 64
    Engage the seal in the retaining formed section
    groove.

    12436R

    PRE6401
    Slide the seal so that the end (A) is positioned with
    the corner of the windscreen aperture.
    REMOVAL - REFITTING
    Close and lock the hood.
    After removing the front locks and the trims, re-
    move the seal. Check the sideways alignment with the hood seal.

    A clearance of 1 mm must be obtained between


    the seals (longitudinal clearance).

    12437S

    Moisten the seal (glass cleaner, soapy water).

    64-1

    You might also like