Scribd
Upload
225 views4 pages

Topic 4: Analysis Methods: Branch Current Method

This document discusses three circuit analysis methods: branch current method, loop/mesh current method, and node voltage method. For each method, the document outlines the key steps and provides examples of applying the methods to solve for unknown currents or voltages in circuits. It also discusses three approaches to solving the resulting simultaneous equations: algebraic substitution, using determinants, and with a calculator.

Uploaded by

Umakandan Muniandy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
225 views4 pages

Topic 4: Analysis Methods: Branch Current Method

This document discusses three circuit analysis methods: branch current method, loop/mesh current method, and node voltage method. For each method, the document outlines the key steps and provides examples of applying the methods to solve for unknown currents or voltages in circuits. It also discusses three approaches to solving the resulting simultaneous equations: algebraic substitution, using determinants, and with a calculator.

Uploaded by

Umakandan Muniandy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

Topic 4: Analysis Methods

Branch current method

In the branch current method, you can solve for the currents in a circuit using
simultaneous equations.Steps:

1. Assign a current in each branch in an arbitrary direction.


2. Show polarities according to the assigned directions.
3. Apply KVL in each closed loop.
4. Apply KCL at nodes such that all branches are included.
5. Solve the equations from steps 3 and 4.
Find the branch currents for circuit below.

Loop ( Mesh) current method

In the loop current method, you can solve for the currents in a circuit using
simultaneous equations. Steps:

1. Assign a current in each nonredundant loop in an arbitrary direction.


2. Show polarities according to the assigned direction of current in each loop.
3. Apply KVL around each closed loop.
Solve the resulting equations for the loop currents

1
Loop current method applied to circuits with more than two loops
The advantage to the loop method for the bridge is that it has only 3 unknowns.

Write the loop current equation for Loop A in the Wheatstone bridge:

Node voltage method


In the node voltage method, you can solve for the unknown voltages in a circuit
using KCL.
Steps:
1. Determine the number of nodes.
2. Select one node as a reference. Assign voltage designations to each
unknown node.
3. Assign currents into and out of each node except the reference node.
4. Apply KCL at each node where currents are assigned.
5. Express the current equations in terms of the voltages and solve for the
unknown voltages using Ohm’s law.

2
Solving Simultaneous Equations
Three methods for solving simultaneous equations are
 Algebraic substitution
 The determinant method
 Using a calculator

Solve for IA using substitution


ABAB 1270100010
ABAB 1270100010 100016806
100016806 IIII IIII

Solve the same equations using determinants

 1270 10 
 
 1000 6 
IB 
 1270 1000 
 1000 1680 
 

Solving Simultaneous Equations using calculator

a1,1 x1  a1,2 x2  b1
a2,1 x1  a2,2 x2  b2
Exercises
1. Use branch current methods to find each branch current

2. Use the mesh current method, find the branch currents

9.5
3
mA 3
3. Find I3

4. Use the node analysis method to find VA and VB

A B

You might also like