Scribd
Upload
49 views

Chapter 16 Exercises - Mechanical Engineering Autocad 2004 Instructor

CHAPTER 16 exercises - Mechanics and electronics. Create a flanged sleeve and a cam plate using Lines and Arcs or Circles. Use the Pedit command to convert existing lines to Plines with a Width of.1. Add the necessary center and hidden lines.

Uploaded by

W.G.D.Fernando
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
49 views

Chapter 16 Exercises - Mechanical Engineering Autocad 2004 Instructor

CHAPTER 16 exercises - Mechanics and electronics. Create a flanged sleeve and a cam plate using Lines and Arcs or Circles. Use the Pedit command to convert existing lines to Plines with a Width of.1. Add the necessary center and hidden lines.

Uploaded by

W.G.D.Fernando
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

AutoCAD 2004 Instructor Chapter 16 Exercises - Mechanical Engineering

CHAPTER 16 EXERCISES

1. Flanged Sleeve
Complete the flanged sleeve shown in Figure ME16-1
Figure ME16-1. Create Layers for each of
the separate line types. Assign appropri-
ate Lineweights to the layers as shown in
the figure such as .05” for object lines and
.025” for hidden and center lines. Use the
Properties palette to move all continuous
lines to a Layer called Geometry. Save
the drawing as CH16EX1-M.

Figure ME16-2
2. Plate
Open the CH8EX2 drawing from Chapter 8
exercises. Draw Lines on the current layer
to represent the center lines shown in Figure
ME16-2. Next create an appropriate Layer
and Linetype for center lines and use
Properties to place the lines on the proper
layer. Save the drawing as CH16EX2-M.

Copyright 2004 The McGraw-Hill Companies. All rights reserved.


AutoCAD 2004 Instructor Chapter 16 Exercises - Mechanical Engineering

3. Cam Plate Figure ME16-3


Draw the cam plate shown in
Figure ME16-3 using Lines and
Arcs or Circles. When finished,
use the Pedit command and
convert the existing Lines and
Arc to Plines with a Width of .1.
Add the necessary center and
hidden lines. Save the drawing
as CH16EX3-M.

4. Displacement Diagram
Draw the cam displacement diagram as shown in Figure ME16-4. First, draw one horizontal
Line and use the Divide command to help lay out 13 equally spaced vertical lines. Draw half
of a Circle at the left-most vertical line and Array the vertical line 7 times to fill 180 degrees.
Construct the respective horizontal projection lines from the ends of the radial lines. Place a
Donut at each line intersection, then use the Spline command to draw the cam profile. Trim as
necessary. Save the drawing as CH16EX4-M.

Figure ME16-4

Copyright 2004 The McGraw-Hill Companies. All rights reserved.

You might also like