Scribd
Upload
47 views20 pages

Conversion From Non

The document provides instructions for converting a system from non-unicode to unicode. It instructs the user to activate the i18n system configuration in SE16, check that the TCPDB table only contains one entry indicating a single code page system, and run the RSCP0126 report in SE38 to start additional preparations for the conversion to unicode.

Uploaded by

Ramakrishna Reddy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
47 views20 pages

Conversion From Non

The document provides instructions for converting a system from non-unicode to unicode. It instructs the user to activate the i18n system configuration in SE16, check that the TCPDB table only contains one entry indicating a single code page system, and run the RSCP0126 report in SE38 to start additional preparations for the conversion to unicode.

Uploaded by

Ramakrishna Reddy
Copyright
© Attribution Non-Commercial (BY-NC)
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 20

Conversion from Non-unicode to Unicode

I18N Tcode

Click on > i18n system configuration


Click on Activate
Go to SE16 and enter TCPDB and execute
Click on number of entries

If this table contains only one entry,Its is sigle code page system
R

Run a report in Se38 RSCP0126


Click on Update
Start additional preparations

You might also like