06n Rr410305 Refrigeration Air Conditioning

www.andhracolleges.
com The Complete Information About Colleges in Andhra Pradesh
Code No: RR410305 Set No. 1

IV B.Tech I Semester Regular Examinations, November 2006
REFRIGERATION & AIR CONDITIONING
(Mechanical Engineering)
Time: 3 hours Max Marks: 80
Answer any FIVE Questions
All Questions carry equal marks
⋆⋆⋆⋆⋆
www.andhracolleges.com
1. (a) Explain the boot strap air cycle refrigeration system with a schematic and
cycle diagrams.
(b) Derive an expression for the COP of Bell- Coleman cycle.
2. (a) Define the unit of refrigeration.

(b) A refrigerator using Ammonia works between the temperatures -10 deg. C
[8]
and 25 deg. C. The gas is dry at the end of compression and there is no under
cooling of liquid. Using the tables, Calculate the theoretical COP of the cycle.
[14]
[8]
[2]
3. (a) Explain the working of a rotary screw compressor. [10]

(b) How the capacity control is achieved in refrigerant compressor? [6]
4. (a) Explain the working of an evaporative condenser. [10]

(b) Give the comparison of flooded evaporators and dry evaporators. [6]
5. (a) What are the characteristics of ideal absorbent and refrigerant mixture in
vapour absorption refrigeration. [8]
(b) Explain with a simple sketch the construction of Electrolux refrigeration sys-
tem. [8]
6. In a Steam jet refrigeration system dry saturated steam at 7 bar abs. pressure
is supplied. The flash chamber temperature is 5o C, the condenser temperature is
40o C, make up water is supplied at 20o C. Assuming that quality of motive steam
and flash vapour at the beginning of compression as 93% dry and efficiency of the
nozzle, efficiency of entertainment and the efficiency of the thermo-compressor as
90%, 65%and91% respectively. Determine:
(a) Weight of steam required per hour per ton of refrigeration.

(b) The volume of vapour removed from the flash chamber per hour per ton of
refrigeration. [16]
7. (a) Define the term “effective temperature” and explain its importance in air-
conditioning systems. Describe the factors which affect the effective temper-
ature.
[8]
(b) Define the “human comfort” and describe the factors which affect the human
comfort. [8]
Seminar Topics - Scholarships - Admission/Entrance Exam Notifications
1 ofUSA-UK-Australia-Germany-France-NewZealand
2 Universities List
www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

www.andhracolleges.com The Complete Information About Colleges in Andhra Pradesh

8. (a) Explain the working principle of a heat pump which makes use of Rankine
power cycle with a neat diagram [8]
(b) Explain solar energy assisted heat pumps by drawing the circuit. [8]
⋆⋆⋆⋆⋆
2 Universities List


⋆⋆⋆⋆⋆
1. (a) What is the difference between a refrigerator and a heat pump?
(b) The capacity of a refrigerator is 200 TR when working between - 8o C and
26o C. Determine the mass of ice produced per day from water at 260 C. Also
find the power required to drive the unit. Assume that the cycle operates on
reversed carnot cycle and latent heat of ice is 335 kJ/kg.
2. A simple vapour compression cycle using F-12 is designed to take a load of 10
[12]
tons. The refrigerator and ambient temperatures are 00 C and 300 C respectively.
A minimum temperature of -50 C is required in evaporator and condenser for heat
transfer. Find
[4]
(a) Mass flow rate through the system

(b) Power required in kW
(c) Cylinder dimensions assuming L/D ratio as 1.2 for a single cylinder and single
acting compressor running at 300 RPM with a volumetric efficiency of 0.9 [16]
4. (a) Differentiate between flooded type and dry expansion type evaporators. [6]
(b) Explain the working of thermostatic expansion valve with the help of a neat
sketch. [10]
5. (a) What are the characteristics of ideal absorbent and refrigerant mixture in
vapour absorption refrigeration. [8]
(b) Explain with a simple sketch the construction of Electrolux refrigeration sys-
tem. [8]
6. (a) What are the limitations of steam jet refrigeration system. [8]
(b) What are the merits of steam jet refrigeration system over other system? [8]
7. (a) A quantity of air having a volume of 300 m3 at 30o C (DBT) and 25o C (WBT)
is heated to 40o C (DBT). Estimate the amount of heat added, final relative
humidity and WBT. The air pressure is 1.01325 bar. [6]
(b) 800m3 /min of re-circulated air at 22o C (DBT) and 10o dew point tempera-
ture is to mixed with 300 m3 /min of fresh air at 30o C (DBT) and 50% RH.
Determine the enthalpy, specific volume, humidity ratio and dew point temp
of the resultant mixture. [10]
2 Universities List


8. (a) With a simple sketch explain the principle of centrifugal dust collector. [6]
(b) List the different methods of odour removal from air and write short notes on
any three methods. [10]
⋆⋆⋆⋆⋆
2 Universities List


⋆⋆⋆⋆⋆
1. (a) Explain the importance of Industrial Refrigeration citing specific cases.
(b) Distinguish between vapour absorption and vapour compression system and
what is the distinct advantage of vapour absorption over vapour compression
system. [4]
(c) Explain the working principle of vapour compression refrigeration system with
a neat diagram and also plot the same on a P-h and T-s diagram
2. (a) Derive an expression for COP of vapour compression cycle from t-s chart when
the refrigerant is dry saturated before compression.
[8]
[6]
[4]
(b) A vapour compression machine is used to maintain a temperature of -230 C in

a refrigerated space. The ambient temperature is 37o C. The compressor takes
in dry saturated vapour of F- 12. A minimum 100 c temperature difference is
required at the evaporator as well as at condenser. There is no sub cooling of
the liquid If the refrigerant flow rate is 1 kg/min, Find
(i) tonnage of refrigeration

(ii) power requirement
(iii)Ratio of COP of this cycle to COP of carnot cycle.
3. (a) Explain the working of a rotary screw compressor.

(b) How the capacity control is achieved in refrigerant compressor?
4. (a) Explain the working of an evaporative condenser.

(b) Give the comparison of flooded evaporators and dry evaporators.
5. The following efficiencies must be assumed

Isentropic efficiency of turbine = 90%
[10]
[10]
[6]
[10]
[6]
Steam jet refrigeration nozzle efficiency = 90%

Entrainment efficiency = 65%
Thermo compressor efficiency = 65%
The steam enters the thermo compressor at 0.01 bar and with dryness fraction of
0.94, make up water enters the flash chamber at 180 C
determine (using Mollier diagram)
(a) State of steam at all salient points

(b) Quantity of steam leaving the flash chamber
USA-UK-Australia-Germany-France-NewZealand Universities List
www.andhracolleges.com 1 of 2
Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

(c) Quality of steam generated in the boiler
(d) COP of the steam jet refrigeration system based on the heat in put of the
motive steam
Assume the same condenser for power turbine and steam jet refrigeration.
6. (a) How can you produce the cold with the vortex tube? [6]
(b) What is the principle in steam jet refrigeration. Explain with neat sketch.[10]
7. (a) An air water vapor mixture at 1 bar and 26.7o C has a specific humidity of
0.0085. Determine the percentage saturation.
culate
(a) vapor pressure

(b) relative humidity
(c) specific humidity
(d) degree of saturation
[6]
(b) In a laboratory test a psychrometer recorded 36o C DBT and 30o C WBT cal-
(e) dew point temperature

(f) enthalpy of the mixture [10]
8. (a) A heat pump uses water at 10C as the source of heat and the air supplied to
the room is to be at 350 C. If the actual EPR attained is 70% of the reversed
carnot cycle operating between the same temperatures, determine
i. The actual EPR of the heat pump system
ii. The power required to run the compressor if required heat load is 60,000
KJ/hr.
The power required to run the compressor if required heat load is 60,000
KJ/hr. [10]
(b) What are the different constructional features used in heat pump to improve
the overall EPR? [6]
⋆⋆⋆⋆⋆

2 Universities List


⋆⋆⋆⋆⋆
1. (a) Give a brief description of an ideal cycle of air refrigeration.
(b) A carnot refrigerator and a heat pump are supplied with equal amount of
work. The refrigerator operates between -270 C and +270 C and the heat pump
operates between + 450 C and + 270 C. The refrigerator absorbs 4000 kJ/ min
at -270 C. The heat pump absorbs all the heat rejected by the refrigerator and
supplies at 450 C. Compute
(i) COP of refrigerator

[6]
(ii) COP of heat pump

(iii)heat available at + 450 C and
(iv) work input to each unit. [10]
2. (a) Describe the use of liquid vapour regenerative heat exchanger in a vapour
compression system [6]
(b) A simple saturation ammonia compression system has a high pressure of 1.35
MN/m2 and low pressure of 0.19 MN/m2 . Find per 400,000kJ/h of refrigerat-
ing capacity the power consumption of the compressor and COP of the cycle.
[10]

4. (a) Explain the working of an evaporative condenser. [10]

(b) Give the comparison of flooded evaporators and dry evaporators. [6]
5. (a) What is the effect of inert gas in three fluid refrigeration system. [4]
(b) What is absorption refrigeration system and how it differs from convention
vapour compression system and explain its working. [8]
(c) What is Carnot COP of absorption refrigeration system. How it is differ from
actual COP. [4]
6. (a) With the help of a sketch of the processes on Mollier chart explain how the
refrigeration is produced in steam jet refrigeration system. [10]
(b) What difference does it make when the steam jet refrigeration system operates
with a barometric condenser instead of a surface condenser? [6]
USA-UK-Australia-Germany-France-NewZealand Universities List
www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law
1 of 2 Colleges Information

7. An auditorium of 100 seating capacity of conditioned for the given specifications
Out door conditions - 35 and 65% RH
Required air inlet conditions - 15o C and 40 RH.
The required condition is achieved first by cooling and dehumidifying and then by
heating. Find the following
(a) The capacity of the cooling coil in tons of refrigeration
(b) Capacity of the heating coil in kW
(c) By-pass factor of the heating coil if the surface temp of the coil is 22o C [16]
8. (a) Define the following in relation to the conditioned supply air to room ‘Throw’,
‘Drop’ and ‘Spread’. [6]
(b) State the different types of supply air out lots.
(c) Describe the factors governing the selection and location of supply air outlets.
[4]
⋆⋆⋆⋆⋆
2 Universities List

06n Rr410305 Refrigeration Air Conditioning

Uploaded by

Copyright:

Available Formats

06n Rr410305 Refrigeration Air Conditioning

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

06n Rr410305 Refrigeration Air Conditioning

Uploaded by

Copyright:

Available Formats

www.andhracolleges.

com The Complete Information About Colleges in Andhra Pradesh

Code No: RR410305 Set No. 1

2. (a) Define the unit of refrigeration.

3. (a) Explain the working of a rotary screw compressor. [10]

4. (a) Explain the working of an evaporative condenser. [10]

(a) Weight of steam required per hour per ton of refrigeration.

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

Code No: RR410305 Set No. 1

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

Code No: RR410305 Set No. 2

(a) Mass flow rate through the system

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

Code No: RR410305 Set No. 2

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

Code No: RR410305 Set No. 3

(b) A vapour compression machine is used to maintain a temperature of -230 C in

(i) tonnage of refrigeration

3. (a) Explain the working of a rotary screw compressor.

4. (a) Explain the working of an evaporative condenser.

5. The following efficiencies must be assumed

Steam jet refrigeration nozzle efficiency = 90%

(a) State of steam at all salient points

Code No: RR410305 Set No. 3

(a) vapor pressure

(e) dew point temperature

Seminar Topics - Scholarships - Admission/Entrance Exam Notifications

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

Code No: RR410305 Set No. 4

(i) COP of refrigerator

(ii) COP of heat pump

3. (a) Explain the working of a rotary screw compressor. [10]

4. (a) Explain the working of an evaporative condenser. [10]

Code No: RR410305 Set No. 4

(a) The capacity of the cooling coil in tons of refrigeration

www.andhracolleges.com Engineering-MBA-MCA-Medical-Pharmacy-B.Ed-Law Colleges Information

You might also like