Scribd Logo
Upload

Welcome to Scribd!

  • 39 views

    Drill Machine 2

    Uploaded by

    ittehad
    When using a drill machine, workers must wear safety glasses and ensure any chuck keys are removed before operating. The stock being drilled must be securely clamped to prevent spinning or movement, and electrical cables should be checked before powering on. Drill bits used must be sharp, and the drill should be run at appropriate speeds for the job to avoid breaking bits or injuries.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    Drill Machine 2

    Uploaded by

    ittehad
    39 views1 page
    When using a drill machine, workers must wear safety glasses and ensure any chuck keys are removed before operating. The stock being drilled must be securely clamped to prevent spinning or movement, and electrical cables should be checked before powering on. Drill bits used must be sharp, and the drill should be run at appropriate speeds for the job to avoid breaking bits or injuries.

    Original Description:

    Drill Machine 2

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    When using a drill machine, workers must wear safety glasses and ensure any chuck keys are removed before operating. The stock being drilled must be securely clamped to prevent spinning or movement, and electrical cables should be checked before powering on. Drill bits used must be sharp, and the drill should be run at appropriate speeds for the job to avoid breaking bits or injuries.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    39 views1 page

    Drill Machine 2

    Uploaded by

    ittehad
    When using a drill machine, workers must wear safety glasses and ensure any chuck keys are removed before operating. The stock being drilled must be securely clamped to prevent spinning or movement, and electrical cables should be checked before powering on. Drill bits used must be sharp, and the drill should be run at appropriate speeds for the job to avoid breaking bits or injuries.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    of 1

    SAFE WORK REQUIREMENT

    HSE/SWR 348
    Drill Machine Procedure

    Sinopec International
    Petroleum Service
    Corporation
    Version
    : 03
    Classification : Internal

    : 03

    :
    Amend No

    : 01
    : 01

    valid From
    Approved

    : 2011-09-01

    Validity Area : All Activity location


    :

    : 2011-09-01

    Drill Machine Procedure:


    When using the drill, safety glasses, goggles or full face shield must be worn.
    Prior to operation, be sure the chuck key is out of the chuck.
    Do not operate with loose clothing.
    Check electrical cables and connections to ensure insulation is good before switching on
    machine.
    When drilling, securely clamp the stock to prevent spinning or climbing the drill.
    If stock is not clamped securely, turn off the drill. In no case rely on your hands to secure the
    stock.
    Do not use dull bits.
    Run the drill at speeds appropriate to the work.
    Feeding a bit too fast can break the bit and cause injury.

    You might also like