Scribd
Upload
217 views2 pages

Flexible Parser CSEPreProcessLine

The document discusses a new method called CSEPreprocessLine that can be used to preprocess NC code lines before they are sent to a parser. This method is available in several NX software versions and can help overcome parser problems without needing a new DLL. An example given is using it to support an axis address that a FANUC parser does not normally allow.

Uploaded by

Rob Baylor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
217 views2 pages

Flexible Parser CSEPreProcessLine

The document discusses a new method called CSEPreprocessLine that can be used to preprocess NC code lines before they are sent to a parser. This method is available in several NX software versions and can help overcome parser problems without needing a new DLL. An example given is using it to support an axis address that a FANUC parser does not normally allow.

Uploaded by

Rob Baylor
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Flexible Parser

in ISV CSE

Thomas Schulz
Development Manager
Manufacturing Engineering Software

Siemens AG 2012. All Rights Reserved.

Enhancement for flexible Parser feature


New method in CSE:

CSEPreprocessLine

This method is called for every NC Code line BEFORE the string is send to the
parser

Available in: NX755 MP2

NX802

NX85

Useful to overcome problems of the parser, without the need of a new DLL

Example: FANUC Parser does not support XA as axis address


Check Simulation Discuss (!)

Page 2

Siemens AG 2012. All Rights Reserved.


Siemens PLM Software

You might also like