Scribd
Upload
49 views1 page

Types of Valves Summary

Gate valves are used where low flow resistance is desired when fully open. Globe valves are used where good throttling and low leakage are needed, accepting higher head loss when open. Ball valves allow quick on-off but have poor throttling. Plug valves direct flow between ports through a single valve. Diaphragm and pinch valves isolate the operating mechanism from the fluid. Butterfly valves provide advantages for large applications in weight, space, and cost. Check valves automatically open to allow flow in one direction and close to prevent reverse flow. Stop check valves combine features of lift check and globe valves. Safety valves automatically relieve overpressure. Angle valves are globe valves with inlet and outlet at 90 degrees.

Uploaded by

Sherwin Agoot
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
49 views1 page

Types of Valves Summary

Gate valves are used where low flow resistance is desired when fully open. Globe valves are used where good throttling and low leakage are needed, accepting higher head loss when open. Ball valves allow quick on-off but have poor throttling. Plug valves direct flow between ports through a single valve. Diaphragm and pinch valves isolate the operating mechanism from the fluid. Butterfly valves provide advantages for large applications in weight, space, and cost. Check valves automatically open to allow flow in one direction and close to prevent reverse flow. Stop check valves combine features of lift check and globe valves. Safety valves automatically relieve overpressure. Angle valves are globe valves with inlet and outlet at 90 degrees.

Uploaded by

Sherwin Agoot
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Types of Valves Summary

Foot Valve

Gate valves are generally used in systems


where low flow resistance for a fully
open valve is desired and there is no need to
throttle the flow.

Tape measure
Teflon tape & pipe seal
Plumbbob
Pipe wrench
Nylon cord
Chain wrench
Mechanical level
Adjustable wrench
Scriber
Vise grip
Soapstone or pencil
Hammer
Cold chisel

Globe valves are used in systems where


good throttling characteristics and low
seat leakage are desired and a relatively high
head loss in an open valve is
acceptable.
Ball valves allow quick, quarter turn on-off
operation and have poor throttling
characteristics.
Plug valves are often used to direct flow
between several different ports through
use of a single valve.
Diaphragm valves and pinch valves are
used in systems where it is desirable for
the entire operating mechanism to be
completely isolated from the fluid.
Butterfly valves provide significant
advantages over other valve designs in
weight,
space, and cost for large valve applications.
Check valves automatically open to allow
flow in one direction and seat to prevent
flow in the reverse direction.
Stop check valve is a combination of a lift
check valve and a globe valve and
incorporates the characteristics of both.
Safety/relief valves are used to provide
automatic overpressurization protection for
a system.
Angle valves are globe valves in which the
inlet and outlet openings are at 90deg to one
another.

Pipe Cutting & Threading


Set of screw driver
Pipe vise
Set of combination wrench
Hacksaw
Universal pliers
Pipe cutter
Electric drill machine
File halfround
Set of masonry drill bits
Deburrer
Set of wall plug (TOX)
Pipe threader manual
Set of pipe clamps, fixtures
Pipe threader machine type
Test gauge for final pressure test
Cutting Oil

You might also like