Scribd
Upload
166 views4 pages

Design of Transmission System

Mechanical engineering

Uploaded by

Ricardo Villagómez Gro
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
166 views4 pages

Design of Transmission System

Mechanical engineering

Uploaded by

Ricardo Villagómez Gro
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF or read online on Scribd
You are on page 1/ 4
Vidyarthiplus Important Questions ‘Anna University, Chennai Department of B.£ Mechanical Engineering B.E/B. Tech, DEGREE EXAMINATION May/June 2016 ‘SIXTH SEMESTER ME6601 Design Of Transmission System (REGULATION 2013) 1 Design a chain drive to transmit 6 KW at 900 rpm of a sprocket pinion. Speed reduction’ Driving motor is mounted on an adjustable base. Assume that load is steady, drive i intal and service is 16 hours/day. 2 Design a flat belt drive to transmit 25 kW at 720 rpm to an aoa AQP Fectine with a speed reduction of 3.0. The distance between the shafts is 3 m. = ing machine pulley is 1.2m. ‘A compressor is to be actuated from a 10 KW electric cet of the motor shaft is 1000 rpm and the compressor speed being 350 rpm .the centre distance is S00 mm. the compressor operates 16 hours per day. Design a xe jain drive. 4, Design a v- belt drive and calculate the a It tension and average stress for the following data. Driven pulley diameter, D = 500 ulley diameter, d=150 mm, center distance C= 925 mm, speed Ni =1000 r.p.m, N2 ae power, jate a compressor from 2.12 kW electric motor at 900 r.p.m , the |. Minimum centre distance should be 500 mm, the chain tension maybe The pitch circles of a train of spur gears are shown in fig 3.gear A receives 3.5 kW power at 700 r.p.m through its shaft and rotates in clock wise direction .Gear B is the idler gear while gear Cis the driven gear. The number of teeth on gears A, B and C are 30, 60 and 40 respectively, while the module is 5 mm. calculate the torque on each gear shaft; and the components of gear tooth forces. 7, {Ina spur gear drive for a rock crusher, the gears are made of case hardened alloy steel. The pinion is transmitting 18 KW at 1200 r.p.m with a gear ratio of 3.5.The gear is to work 8hours/day for 3 years. Design the drives major dimensions, check for compressive and bending stresses and sketch the arrangement. A motor shaft rotating at 1440 rpm has to transmit 15 kW to a low speed shaft rotating at 500 rpm

You might also like