CCNP Routing and Switching 300-115 Pass4sure Exam Questions
CCNP Routing and Switching 300-115 Pass4sure Exam Questions
CCNP Routing and Switching 300-115 Pass4sure Exam Questions
300-115 Pass4sure
300-115 Pass4sure
300-115 Pass4sure
After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This
port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state.
Which option describes what causes the port to go into the errdisable state?
A. Normal UDLD operations that prevent traffic loops.
Correct Answer: B
Download 300-115 Pass4sure PDF
300-115 Pass4sure
300-115 Pass4sure
A network engineer must adjust the STP interface attributes to influence root port selection. Which two
elements are used to accomplish this? (Choose two.)
A. port-priority
B. cost
C. forward-timers
D. link type
E. root guard
Correct Answer: AB
Download 300-115 Pass4sure PDF
300-115 Pass4sure
After port security is deployed throughout an enterprise campus, the network team has been overwhelmed
with port reset requests. They decide to configure the network to automate the process of re-enabling user
ports. Which command accomplishes this task?
A. switch(config)# errdisable recovery interval 180
300-115 Pass4sure
C. NDP
D. LLTD
Correct Answer: B
300-115 Pass4sure
A manager tells the network engineer to permit only certain VLANs across a specific trunk interface. Which
option can be configured to accomplish this?
A. allowed VLAN list
B. VTP pruning
C. VACL
D. L2P tunneling
Correct Answer: A
300-115 Pass4sure
While troubleshooting a network outage, a network engineer discovered an unusually high level of broadcast
traffic coming from one of the switch interfaces. Which option decreases consumption of bandwidth used by
broadcast traffic?
A. storm control
B. SDM routing
C. Cisco IOS parser
D. integrated routing and bridging
E. Dynamic ARP Inspection
Correct Answer: A
Download 300-115 Pass4sure PDF
300-115 Pass4sure
Which SDM template disables routing and supports the maximum number of unicast MAC addresses?
A. VLAN
B. access
C. default
D. routing
Correct Answer: A
300-115 Pass4sure
Which SDM template is the most appropriate for a Layer 2 switch that provides connectivity to a large number
of clients?
A. VLAN
B. default
C. access
D. routing
Correct Answer: A
300-115 Pass4sure
300-115 Pass4sure
300-115 Pass4sure
300-115 Pass4sure
Which VTP mode is needed to configure an extended VLAN, when a switch is configured to use VTP versions 1
or 2?
A. transparent
B. client
C. server
D. Extended VLANs are only supported in version 3 and not in versions 1 or 2.
Correct Answer: D
300-115 Pass4sure
Contact us at [email protected]