Scribd
Upload
21 views

Volume Ref 6 Uk

The document discusses setting a reference volume parameter for a flow measurement unit to obtain correct measurements when the test port volume is different than the reference port volume. It may be used with flow units like cm3/min, ml/s, and ml/min. The reference volume value can be adjusted in the program parameters under the name "Ref. VOL.".

Uploaded by

Suranyi Botond
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
21 views

Volume Ref 6 Uk

The document discusses setting a reference volume parameter for a flow measurement unit to obtain correct measurements when the test port volume is different than the reference port volume. It may be used with flow units like cm3/min, ml/s, and ml/min. The reference volume value can be adjusted in the program parameters under the name "Ref. VOL.".

Uploaded by

Suranyi Botond
Copyright
© © All Rights Reserved
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Sheet #615u Reference Volume

REFERENCE VOLUME
.1 PRESENTATION
The program uses the programmed test volume to measure the normal flow at the test port.
When the reference port volume is different the test port volume, it is possible to set parameters
for the exact value of the reference volume to obtain correct measurements in the event of
results displaying negative values.
This function may only be used with flow measurement units: cm 3/min, cm3/s, cm3/h, mm3/s,
ml/s, ml/min or ml/h.

.2 PARAMETRING
Ensure that the reject unit is a flow unit (see
above).
Activate the function or check if it checked.
Press the

key, the cursor slide to the


right hand.active.

By using the
"Yes" and validate with the

arrows, select
key.

Adjust the reference volume value.

This parameter is also available in the


program parameters under the name
"Ref. VOL.".

Version 1.04a

User guide ATEQ 6th series Page 1/1

You might also like