Scribd
Upload
41 views1 page

Cut Off 6 Uk

This document describes the "CUT OFF" function, which sets all measurement values below a configured percentage to zero. To use the function, select it from the menu using arrow keys and confirm with the enter key. Then adjust the "% CUT OFF" parameter to determine the percentage below which values will be displayed as zero.

Uploaded by

Suranyi Botond
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
41 views1 page

Cut Off 6 Uk

This document describes the "CUT OFF" function, which sets all measurement values below a configured percentage to zero. To use the function, select it from the menu using arrow keys and confirm with the enter key. Then adjust the "% CUT OFF" parameter to determine the percentage below which values will be displayed as zero.

Uploaded by

Suranyi Botond
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Sheet #686u "Cut off" Fonction

"CUT OFF" FUNCTION


.1 PRESENTATION
With the CUT OFF function, all the measurements less than the configured percent will have the
value 0.

.2 PROCEDURE

Check the function is not hidden.


Then press the

key, the cursor switch

to the right hand.

By using the
"Yes" and validate with the

arrows, select
key.

Then adjust the % CUT OFF parameter that


all the measurements under this percent value
will be displayed 0.

Version 1.04a

Guide dutilisation ATEQ Srie 6 Page 1/1

You might also like