Scribd
Upload
721 views

VO Coding Step-By-Step Guide

The document outlines 12 steps to recode ECUs in a vehicle to enable Dazzle LEDs. It involves opening ESYS, reading the vehicle order file and saving it, editing the SALAPA-element, saving changes to the file, loading the file back into ESYS, calculating the FP, writing the new FA and FP to the vehicle, reading the ECUs, and coding the applicable ECUs which are typically FEM_BODY and KAFAS2 for Dazzle LEDs. Repeating step 12 codes any remaining ECUs as needed.

Uploaded by

Tudorel Iancu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
721 views

VO Coding Step-By-Step Guide

The document outlines 12 steps to recode ECUs in a vehicle to enable Dazzle LEDs. It involves opening ESYS, reading the vehicle order file and saving it, editing the SALAPA-element, saving changes to the file, loading the file back into ESYS, calculating the FP, writing the new FA and FP to the vehicle, reading the ECUs, and coding the applicable ECUs which are typically FEM_BODY and KAFAS2 for Dazzle LEDs. Repeating step 12 codes any remaining ECUs as needed.

Uploaded by

Tudorel Iancu
Copyright
© © All Rights Reserved
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 13

Step

1 Open ESYS, Make proper connection and open Expert Mode; Coding Tab

In this example, we will remove Dazzle DeCoding and ReCode the ECUs to enable Dazzle LEDs

Step 2 Read Vehicle Order (FA), then save the file to your desktop, as we will make changes and
then write those changes to the vehicle, so that they are permanent.

Step 3 Expand the FA tree, until you get to SALAPA-element.


Step 4 Right-Click on SALAPA-element and click the Edit option.


Step 5 Make your desired changes in the box below the FA-tree and then click the apply changes
button.

Step 6 Go back to the FA-tree, right-click on FA, then select calculate FP


Step 7 Press the diskette button at the top of the screen to save your changes to the file on your
desktop.

Step 8 Under Expert Coding, select VCM Then in the bottom section, press the button and
locate the file you saved earlier on your desktop


Step 9 Once the file is loaded, Under the Vehicle Order section, right-click FA and select calculate
FP

Step 10 Once FP is calculated press the master tab at the bottom of the screen, and select the
Write FA & FP button look at the very bottom of the screen for confirmation of FA & FP written

Step 11 Return to Expert Mode; Coding then press Read ECU under the SVT section

Step 12 Find the applicable ECU(s) that need to be VO_Coded, and right-click on that ECU (as
shown below) and click Code

Repeat Step 12 for any remaining ECUs that need to be VO_Coded



The most popular VO_Coding changes require coding to the following ECUs

Dazzle LEDs: FEM_BODY & KAFAS2 . Or FEM_BODY & FLA3
Satellite Radio / Enhanced Bluetooth: HU_NBT or HU_ENTRY & CMB_MEDIA

You might also like