Scribd
Upload
756 views1 page

Srt7004 Usb SW Update en

The document provides instructions for performing a software update on an SRT 7004 receiver using a USB drive. Key steps include downloading the software file and copying it to the root folder of a FAT32 formatted USB drive, inserting the USB drive into the front port of the receiver, selecting the update option from the menu, choosing the USB drive, and initiating the update which will take some time to complete. The receiver should not be powered off or have the USB drive removed during the update process.

Uploaded by

Paul Gabriel Bălteanu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
756 views1 page

Srt7004 Usb SW Update en

The document provides instructions for performing a software update on an SRT 7004 receiver using a USB drive. Key steps include downloading the software file and copying it to the root folder of a FAT32 formatted USB drive, inserting the USB drive into the front port of the receiver, selecting the update option from the menu, choosing the USB drive, and initiating the update which will take some time to complete. The receiver should not be powered off or have the USB drive removed during the update process.

Uploaded by

Paul Gabriel Bălteanu
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

SRT 7004 Software Update with USB

The upgrade can be performed with a USB device, preferably a USB pen drive, which must be
formatted in FAT32.

NOTE: The USB port on the front is specifically adapted for software updates and backups.

1. Download the file to your computer and unzip the file, and then copy it to the root folder of
your USB storage device.
2. Connect the USB storage device to the front USB port of the receiver.
3. Press MENU on the remote control and select System -> Update & Backup -> Image
Upgrade.
4. Select the appropriate USB device (USB0 or USB1).
5. Press OK to enter the software file list and select the file containing the software image with
and press OK to initiate the software update. An attention banner will now be
displayed.
6. Press OK to start the update (or EXIT to cancel it).

Follow the instructions which are displayed on screen. The update process will take some time.
After the update process has been completed, the receiver will reboot and the receiver will start
with the first time installation.

Warning: NEVER power off the receiver or remove the USB device during the software update
process. Doing so might cause irreparable damage to your receiver and will void your warranty.

www.strong.tv

You might also like