Scribd
Upload
70 views2 pages

Documenttype 1 (2) Typeunitordepartmenthere Typeyournamehere Typedatehere

This document provides a list of commands and their purposes related to monitoring and troubleshooting a mobile network. Some examples include commands to check site status (ZEEI), see blocked transactions (ZEEL:BL), check alarms (ZEOL:BCF NO), cancel an alarm (ZEOR:BCF NO:ALARM NO), reset a site (ZEFS:BCF NO:L/U), and change a BTS power level (ZEUG:BTS=BTS NO:PMAX1=(1,2...43)). The document also defines various network units like the OMU, MCMU, BCSU, ET, and provides their purposes.

Uploaded by

deepak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
70 views2 pages

Documenttype 1 (2) Typeunitordepartmenthere Typeyournamehere Typedatehere

This document provides a list of commands and their purposes related to monitoring and troubleshooting a mobile network. Some examples include commands to check site status (ZEEI), see blocked transactions (ZEEL:BL), check alarms (ZEOL:BCF NO), cancel an alarm (ZEOR:BCF NO:ALARM NO), reset a site (ZEFS:BCF NO:L/U), and change a BTS power level (ZEUG:BTS=BTS NO:PMAX1=(1,2...43)). The document also defines various network units like the OMU, MCMU, BCSU, ET, and provides their purposes.

Uploaded by

deepak
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 2

DOCUMENTTYPE

TypeUnitOrDepartmentHere
TypeYourNameHere

1 (2)

TypeDateHere

1. ZEEI; // To see the status of the site.


2. ZEEP; // To see all the site & its BCF IDs.
3. ZEEL:BL; // To see the Blocked TRX in whole BSC.
4. ZEOL:BCF NO; // To check the current alarm in the site.
5. ZEOH::BCF=BCF NO; // To check history of alarm.
6. ZEOR:BCF NO:ALARM NO(10001-65534); // To cancel an alarm.
7. ZEFS:BCF NO:L/U; // To give site reset.
8. ZEFR:BCF NO:SITE/OMU; // To give site reset in safe mode also OMU reset.
9. ZEQS:BTS=BTS NO:L/U; // To give sector reset.
10. ZERS:BTS=BTS NO,TRX=TRX NO:L/U; // To give TRX reset.
11. ZERM:BTS=BTS NO,TRX=TRX NO:GTRX=Y/N; // To give reset if TRX is blocked by system.
12. ZERM:BTS=BTS NO,TRX=TRX NO:PREF=P/N; // To change preference for ACTIVE TRX.
13. ZWAT; // To check BSC alarm TEXT ID.
14. ZAHO::NR=4000-4007; // To check BSC alarm.
15. ZAHO:ET,ET NO; // To check ET alarm.
16. ZAHP; // To check ET & BSC history alarms.
17. ZYEF:ET,ET NO; // To check PCM service state.
18. ZDTI:::PCM=ET NO; // To check signalling link for a site.
19. ZDSB:::PCM=ET NO; // To check TIE value & BIT rate.
20. ZUSC:ET,ET NO:BL/WO; // To give ET reset.
21. ZDTC:LAPD NAME:BL/WO; // To give LAPD reset.
22. ZYMO:ET,ET NO; // To check SLIPS.
23. ZUSI:ET,ET NO; // To check ET status.
24. ZWUP:ET NO; // To check the type of ET (ABIS or SIGNALLING).
25. ZERO:BCF=BCF NO; // To check traffic of the TRX.
26. ZESI:ID=BCF NO; // To check EDAP.
27. ZESI:ID=BCF NO:TRXS; // To check DAP TRX.
28. ZQUS:BCF=BCF NO,TRE=(RATIO);then 7;1;0; // To check receiving level.
29. ZNEL; // To check signalling link status.
30. ZEFP; // To check External Alarm ID.
31. ZEFT:BCF NO:ON/OFF; // To switch ON/OFF the DG.
32. ZEFO:BCF NO:IOP; // To check POLARITY.
33. ZEFX:BCF NO:INBR=INPUT ID:POL=OPEN/CLOSED; // To change the POLARITY.
34. ZEWV:BCF NO:BU; // To give SOFTWARE BACKUP.
35. ZEQE:BTS=BTS NO:AHOP=Y/N; // To remove ANTENNA HOP if PRESENT.

DOCUMENTTYPE
TypeUnitOrDepartmentHere
TypeYourNameHere

TypeDateHere

36. ZEUO:BTS=BTS NO; // To check BTS POWER.


37. ZEUG:BTS=BTS NO:PMAX1=(1,243); // To change BTS POWER.
38. ZEQV:BTS=BTS NO:GENA=Y/N; // To enable/disable GPRS.
39. ZEQO:BTS=BTS NO:GPRS; // To check GPRS ENABLED OR NOT for BTS.
40. ZFWO:BCSU=0&&6; // To check GPRS for particular BSC.
41. ZACC:CONSECUTIVE NO(XXXX); // To delete BSC Alarm.

BTS UNITS:
OMU

OPERATION & MAINTENANCE UNIT

MCMU MARKER AND CELLULAR MANAGEMENT UNIT


BCSU

BASE STATION CONTROLLER SIGNALLING UNIT

CLS

CLOCK & SYNCHRONIZATION UNIT

MB

MESSAGE BUS

ET

EXCHANGE TERMINAL

TCSM

TRANSCODER SUBMULTIPLEXER

GENA GPRS ENABLED

2 (2)

You might also like