Scribd
Upload
68 views

Computer Lab 1

This document provides instructions for a MATLAB simulation of the logistic map. Students are asked to: 1) Write a code to generate orbits for any initial value and control parameter r, 2) Experiment with periodic and aperiodic dynamics, 3) Modify the code to create a bifurcation diagram of x vs r by varying r, 4) Generate orbits around the period-3 window and examine it at finer resolution, and 5) Further explore the bifurcation diagram by increasing r resolution and describe results in a file to upload.

Uploaded by

Rajesh Ramesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
68 views

Computer Lab 1

This document provides instructions for a MATLAB simulation of the logistic map. Students are asked to: 1) Write a code to generate orbits for any initial value and control parameter r, 2) Experiment with periodic and aperiodic dynamics, 3) Modify the code to create a bifurcation diagram of x vs r by varying r, 4) Generate orbits around the period-3 window and examine it at finer resolution, and 5) Further explore the bifurcation diagram by increasing r resolution and describe results in a file to upload.

Uploaded by

Rajesh Ramesh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Nonlinear dynamics & chaos

Computer Lab 1 (2015-16, Sem-2)


Logistic Map
1. Write a MATLAB code for generating the orbit of a logistic map for any
arbitrary r and initial value x0 .
2. Experiment with the code to get various period-n dynamics, as well as
aperiodic dynamics.
3. Use your code (modify that slightly) to get the bifurcation diagram x vs
r for the logistic map. You will have to choose the resolution of r, r for
which to compute the orbit.
Note: On the bifurcation diagram we only plot those set of points where
the system ends up eventually (at t ). That is, we do not plot the
transients but only the steady state dynamics.
4. Period-3 window
(a) Around the period-3 window, generate the orbit and observe the
intermittently periodic orbit at various r values.
(b) Examine the period-3 window at ner resolution in r.
5. Explore the bifurcation diagram further by increasing the resolution in r
around dierent r values. What do you nd here?
Note: At the end of the laboratory, put in all your results in a single le,
describing the dynamics (period-1, period-2, etc..) and the value of r for each.
Upload the le on photon.

You might also like