0% found this document useful (0 votes)
443 views1 page

Restarting The Enatel Supervisory Module

This document provides instructions for restarting the Enatel Supervisory Module (SM32) while the system remains live. The steps are to first unlock and partially remove the SM32 module, then unplug the pink or black RJ45 cable for 10 seconds before reconnecting it. This should clear any alarms and activate new settings, after which the SM32 is pushed back into place and locked.

Uploaded by

adramat1085
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
443 views1 page

Restarting The Enatel Supervisory Module

This document provides instructions for restarting the Enatel Supervisory Module (SM32) while the system remains live. The steps are to first unlock and partially remove the SM32 module, then unplug the pink or black RJ45 cable for 10 seconds before reconnecting it. This should clear any alarms and activate new settings, after which the SM32 is pushed back into place and locked.

Uploaded by

adramat1085
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Restarting the Enatel Supervisory

Module

Issue: 1
Rev.: 0
Date: 11/08/2011
Page 1 of 1

To Restart the SM32 Supervisory Module while the system


is live

First unlock the SM32 on the right.

Pull the SM32 half way out.


Unplug the Pink or Black RJ45 wire for 10 seconds and then plug it back.

The alarms should be cleared now.


And the new settings should be active.
Push back the SM32, and lock it again.

You might also like