Scribd
Upload
15 views4 pages

ITCD 215 (Fall 2014) Lab - 7 Total Points: 10 Due Date: October 22, 2014, 10:00 PM EST Shane Holbrook

This document provides instructions for a lab assignment due on October 22, 2014. It contains two parts for students to model in NX 9, including creating multi-view drawings and adding dimensions in inches. Students can earn a total of 10 points by completing both modeling tasks and drawings for the two provided parts.

Uploaded by

api-253978194
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
15 views4 pages

ITCD 215 (Fall 2014) Lab - 7 Total Points: 10 Due Date: October 22, 2014, 10:00 PM EST Shane Holbrook

This document provides instructions for a lab assignment due on October 22, 2014. It contains two parts for students to model in NX 9, including creating multi-view drawings and adding dimensions in inches. Students can earn a total of 10 points by completing both modeling tasks and drawings for the two provided parts.

Uploaded by

api-253978194
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

ITCD 215 (Fall 2014)

Lab -7
Total Points: 10
Due date: October 22, 2014, 10:00 PM EST
Shane Holbrook
1. (5 points) Model the part shown below in NX 9. Then create multi-view drawings and add
dimensions. Dimensions are in inches.

2. (5 points) Model the part shown below in NX 9. Then create multi-view drawings and add
dimensions. Dimensions are in inches.

You might also like