Scribd Logo
Upload

Welcome to Scribd!

  • 698 views

    Instruction ME7.4.5 PDF

    Uploaded by

    Alexandre Da Silva Pinto
    This document provides information about an engine control unit (ECU) and instructions for putting the ECU into boot mode. Specifically, it lists pin connections for power supply, ignition, ground, and a K line. It then states that to put the ECU into boot mode, two 6k8 ohm resistors need to be added and one resistor needs to be removed from the ECU. Contact information is also provided for Piasini Engineering.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd

    Instruction ME7.4.5 PDF

    Uploaded by

    Alexandre Da Silva Pinto
    698 views2 pages
    This document provides information about an engine control unit (ECU) and instructions for putting the ECU into boot mode. Specifically, it lists pin connections for power supply, ignition, ground, and a K line. It then states that to put the ECU into boot mode, two 6k8 ohm resistors need to be added and one resistor needs to be removed from the ECU. Contact information is also provided for Piasini Engineering.

    Original Title

    Instruction ME7.4.5.pdf

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This document provides information about an engine control unit (ECU) and instructions for putting the ECU into boot mode. Specifically, it lists pin connections for power supply, ignition, ground, and a K line. It then states that to put the ECU into boot mode, two 6k8 ohm resistors need to be added and one resistor needs to be removed from the ECU. Contact information is also provided for Piasini Engineering.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    698 views2 pages

    Instruction ME7.4.5 PDF

    Uploaded by

    Alexandre Da Silva Pinto
    This document provides information about an engine control unit (ECU) and instructions for putting the ECU into boot mode. Specifically, it lists pin connections for power supply, ignition, ground, and a K line. It then states that to put the ECU into boot mode, two 6k8 ohm resistors need to be added and one resistor needs to be removed from the ECU. Contact information is also provided for Piasini Engineering.

    Copyright:

    © All Rights Reserved
    Download as PDF, TXT or read online from Scribd
    Download as pdf or txt
    of 2

    ECU : PSA_1616v_Me7.4.

    Pin out - Front view :


    Plug C:
    -

    Pin H2
    Pin F4
    Pin H4
    Pin B4

    Power Supply
    Ignition
    Ground
    K Line

    Piasiniengineering [email protected] - http://www.piasiniengineering.it


    Tel: +390342489060 - Fax: +390342488298

    BootStrap's mode:

    You have to put 2 resistor (6K8) for the boot mode and remove 1resistor on the ECU.

    You might also like