Scribd
Upload
2K views2 pages

Instruction Delphi Dcm12

The document provides pinout information for an ECU and instructions for reading it. It lists Pin G1 as power supply, Pin H1 as ground, and Pin B4 as K line for Plug 3 of a Delphi DCM 1.2 ECU. It notes that the blue pin of the bootstrap must be connected to ground to qualify reading the ECU, then power supplied to the ECU before removing the blue pin from ground to identify it.

Uploaded by

Alexandre Da Silva Pinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2K views2 pages

Instruction Delphi Dcm12

The document provides pinout information for an ECU and instructions for reading it. It lists Pin G1 as power supply, Pin H1 as ground, and Pin B4 as K line for Plug 3 of a Delphi DCM 1.2 ECU. It notes that the blue pin of the bootstrap must be connected to ground to qualify reading the ECU, then power supplied to the ECU before removing the blue pin from ground to identify it.

Uploaded by

Alexandre Da Silva Pinto
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

ECU : Delphi DCM 1.

Pin out - Front view :


Plug 3:
Power Supply
Ground
K line

Pin G1
Pin H1
Pin B4

Piasiniengineering [email protected] - http://www.piasiniengineering.it


Tel: +390342489060 - Fax: +390342488298

Now you must pierce the Ecu

Bootstrap's Pin:
The blue pin is the Bootstrap's
Pin, you have to connect to
the ground to qualify the
reading of ECU; then supply
the ECU and when you click
on identify button remove
this pin to the ground

Piasiniengineering [email protected] - http://www.piasiniengineering.it


Tel: +390342489060 - Fax: +390342488298

You might also like