Scribd
Upload
535 views9 pages

Notes - Coherent and Non Coherent Detection

This document discusses coherent and non-coherent detection and demodulation techniques. It provides details on DPSK detection, noting that it does not require a carrier phase reference, allowing for a simpler receiver design, but is less efficient than PSK due to error propagation. Non-coherent FSK is also discussed. The document outlines an assignment on implementing MPSK modulation and demodulation in MATLAB or Simulink for a minimum value of M=8. A report and code are to be submitted by the given deadline.

Uploaded by

Zainab Faydh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
535 views9 pages

Notes - Coherent and Non Coherent Detection

This document discusses coherent and non-coherent detection and demodulation techniques. It provides details on DPSK detection, noting that it does not require a carrier phase reference, allowing for a simpler receiver design, but is less efficient than PSK due to error propagation. Non-coherent FSK is also discussed. The document outlines an assignment on implementing MPSK modulation and demodulation in MATLAB or Simulink for a minimum value of M=8. A report and code are to be submitted by the given deadline.

Uploaded by

Zainab Faydh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 9

Coherent and Non Coherent

Detection/Demodulation
Dr. Syed Anwar
Digital Communication

DPSK Detection
Does not require phase reference of the
received carrier, hence a simpler receiver
design.
Less efficient than PSK due to error
propagation
Error performance of DPSK approximately two
time (3dB) worse than PSK.

Error Performance

Non Coherent FSK


Minimum Tone Spacing

Error Performance

Error Performance

Quadrature Modulator

Assignment 3
Encode an M-ary binary sequence using MPSK. Use Gray code for
binary code and phase assignment.
Add AWGN noise to the encoded signal to generate transmitted
signal si(t) (i= 1,2..M)
Design an MPSK demodulator to detect the M-ary signal using
coherent detection.

Implement using MATLAB or SIMULINK.


The modulator/demodulator should work for a minimum value of
M = 8.

Assignment 3
Maximum group size: 2
Submission Due: 11:59pm , Sunday 9-12-12
Submit code (.m, .mdl) and report (maximum 3 pages) only by
email: [email protected]
Evaluation: Lab session in week following 09-12-12.
Write your own code, no marks for copying code.

25% deduction in marks for each day, in case of late submission.

You might also like