Scribd
Upload
37 views2 pages

Analog Electronics-Ii LAB Paper Code: ETEC - 254 Paper: Analog Electronics II Lab List of Experiments

This document outlines 13 experiments involving operational amplifiers and timers. The experiments include studying op-amps in open and closed loop configurations, using them as adders, subtractors, differentiators, integrators, and in oscillator circuits. Additional experiments involve designing active filters, voltage to current converters, waveform generators using op-amps, and monostable and astable multivibrator circuits using 555 timers.

Uploaded by

Padam Garg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
37 views2 pages

Analog Electronics-Ii LAB Paper Code: ETEC - 254 Paper: Analog Electronics II Lab List of Experiments

This document outlines 13 experiments involving operational amplifiers and timers. The experiments include studying op-amps in open and closed loop configurations, using them as adders, subtractors, differentiators, integrators, and in oscillator circuits. Additional experiments involve designing active filters, voltage to current converters, waveform generators using op-amps, and monostable and astable multivibrator circuits using 555 timers.

Uploaded by

Padam Garg
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

ANALOG ELECTRONICS-II

LAB Paper Code: ETEC- -254


Paper: Analog Electronics II Lab
List of Experiments
1. Introduction to general purpose Operational Amplifier(IC 741) its Pin configuration and

Electrical Characteristics.
2. To study the open loop configuration op-amp (IC 741) as inverting and non-inverting
amplifier.
3.To study the closed loop configuration of op-amp(IC 741) as inverting and non-invertring
amplifier.
4. 3. To study the op-amp (IC 741) as adder, subtractor and voltage follower, calculate its output
voltage
5. Observe and plot the output Wave shape of Op-Amp R-C differentiating circuits, R-C
integrating circuits for square wave input .
6. To study the op-amp (IC 741) as adder, subtractor and voltage follower, calculate its output
voltage.
7. To study Wien Bridge oscillator measurement of frequency and amplitude of oscillations using
Op-Amp.
8. To study RC phase shift oscillator measurement of frequency and amplitude of oscillations
using Op-Amp.
9.Design a low pass/High pass active filter of 1KHz frequency.
10.Construct V to I converter with floating and grounded load.
11. To study the waveform of Schmitt Trigger circuit & Precision Rectifier using 741 OP-AMP
IC.
12. To study the waveform of square wave generator using 741 Op-Amp IC.
13. To make and test the operations of Monostable Multivibrator circuits using 555 timer.
14. To make and test the operations of Astable Multivibrator circuits using 555 timer.

You might also like