Scribd
Upload
80 views

Juniper Router Commands

This document provides commands to check the configuration, interface descriptions, loop status on interface e1-1/0/0, and site status on interface e1-1/0/0. The output of "show interfaces e1-1/0/0 terse" shows that interface e1-1/0/0 is administratively up with a link that is up, while subinterface e1-1/0/0.0 is up but down for internet protocol connectivity.

Uploaded by

Akhilesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
80 views

Juniper Router Commands

This document provides commands to check the configuration, interface descriptions, loop status on interface e1-1/0/0, and site status on interface e1-1/0/0. The output of "show interfaces e1-1/0/0 terse" shows that interface e1-1/0/0 is administratively up with a link that is up, while subinterface e1-1/0/0.0 is up but down for internet protocol connectivity.

Uploaded by

Akhilesh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

1 show configuration | display set

2 show interfaces descriptions


3 show interface e1-1/0/0detail(here we check loop)
Sixth line =device flag here show loop
4 show interface e1-1/0/0 terse(here we check site status)
root@SRI-LOC20-CR-RTR02> show interfaces e1-1/0/0 terse
Interface

Admin

e1-1/0/0

up

e1-1/0/0.0

up

Link Proto

Local

up
down inet

10.100.18.86/30

Remote

You might also like