Louie Simmons - The Lower Back
Louie Simmons - The Lower Back
Louie Simmons - The Lower Back
Louie Simmons
A weak man has a weak back and a strong man has a strong back. Its that simple. But
how do you acquire a strong back without getting hurt? Lets start with large exercises
like rack pulls.
Rack Pulls
Steve Goggins was famous for his back work. He was the first to squat 1100 with
a body weight of 262. Chuck Vogelpohl has always done heavy rack work, and
sometimes he worked up to 1100 or more on high pins. He holds the world record squat
in the 275 bodyweight class at 1150 at an actual bodyweight of 264. I asked him why he
did such heavy rack work. His answer was that it taught him how to strain. I thought if
anyone knows how to strain, its Chuck. But then I realized it. Rack work taught him not
only to strain but to think his way throughout the lift correctly. Most of his rack work was
just below his knees to just above the knees. Mostly singles but sometimes 3 reps were
done for added muscle tension. This is common for Russian and Ukrainian training.
Chuck was so strong off the floor that he had to slow the start to hold onto the bar. His
best meet deadlift was 835, and 900 in the gym with straps. I recommend that those of
you who are not very strong at the floor do some pulls with the plates 2-4 and 6 inches
off the floor.
Good Mornings
A second bar exercise for enormous back strength is good mornings. At Westside, we do
several types of good mornings. I feel the arched lower back, rounded mid to upper back
style is the best for the conventional deadlift. Reps for all except concentric good
mornings should be 3-5 rep maxes. Good mornings can be done with straight legs, bent
legs, rounded back, arched back, or any combination. Use a squat bar, Safety Squat bar, a
14-inch-cambered bar, or a Buffalo bar using a wide or close stance. At Westside, we do
heavy good mornings lowering the plates into large foam blocks.
Zercher Squat
A third heavy bar exercise is the Zercher squat. Westside has developed a harness to do
the lift with little stress on the arms. We do several versions of Zercher lifts off of the
floor like Ed Zercher, the inventor, intended them to be done. Use whatever stance you
like: wide, moderate, or close. Rack work is popular at Westside for the Zercher. Zercher
squats off of a box can also be done. The reps will vary from 1 to 10. Walking with the
Zercher harness loaded with up to 225 for a mile will blow up your lower back, hips,
and hamstrings.
Low Box Squat
For lower back and hip strength the very low box squat is great. If you have never
squatted on a 10-inch or lower box, you are in for a treat. There are two versions of this.
The close stance version will work the quads and lower back. Westside uses the front
squat, Safety Squat bar, Buffalo bar, Zercher squat, and Manta Ray but never a regular
squat bar. A squat bar is too hard on the bicep tendons. Also try very wide stance, low
box squats with any bar mentioned in this article. You want to work up to a 3-5-rep max,
but establish a 1-rep max as well. For weight gain, 5 reps work best. If you have to keep
your weight down, do singles.
pounds for a final set. This was too much volume, but I bought a 195-pound stone with a
T-handle, and 3 sets of 20 reps worked very well. Stand on boxes or benches, round over,
and perform the reps. The wider the feet, the more glute work; the closer the feet, the
more lower back. Milyutin pulled 730 at 220, and Naleykin made 750 and almost 790 at
198. Remember, they use 154 pounds for the reps. We have several 800-pound
deadlifters using 195 pounds.
Sled Work
Sled pulling will raise not only your GPP but also your squat and deadlift. For strength
we pull 200 feet at a time. A strap is placed over your power belt, not on the shoulders.
Do not do less than six trips with very heavy weights: three 45-pound plates to six 45pound plates. As the weight is held to one or two 45-pound plates, the trips can go up to
20 at times. This will greatly raise GPP but will do little for absolute strength. There is
little stress on the spine with sled pulling. It will build the hips, glutes, hamstrings, quads,
calves, and even the lower back. By rotating the hips in a very natural way even when
doing upper body work with a second strap, the lower body is getting a workout. Try sled
work for a boost in your squat and deadlift.
Reverse Hypers
I came up with this exercise in early 1974 after breaking my fifth lumbar vertebra.
Nothing that I had previously done had helped the pain or range of motion, but this
worked. I received my first United States patent in the 1990s. Now I own three U.S.
patents, and Reverse Hyper is U.S. trademarked. This exercise is a decompression tool. It
builds strength to stabilize the core of the muscular skeletal system. This also helps with
the flexibility to perform dynamic motions. To make it simple, it makes you strong while
rehabing the entire back, hamstrings, and glutes. Greg Panora pushed his squat from 920
to 1050 in 18 months. His deadlift has gone from 770 to 800. Luke Edwards deadlift was
740 before coming to Westside, and in 5 months it went to 810. Greg and Luke are both
242-pound lifters. The Reverse Hyper is done at least four times a week, twice very
heavy on squat day. This machine not only builds your lower back and complete
posterior chain but provides decompression of the spinal column and aids in range of
motion. There should be one in every gym, because it will not only build the lower back
to the extreme but is the best prehab and restoration tool available on the market today.
To become extremely strong, one must be healthy and fit; the exercises large and small
discussed here will prolong your lifter career. The great Jon Cole once said the most
important test a lifter has to pass is the test of time. Amen.
Westside Barbell
www.westside-barbell.com
614-801-2060