Scribd
Upload
4K views1 page

ARDUINO Based Foot Step Power Generation ABSTRACT

This document describes a footstep power generation system that converts the mechanical energy from walking or running into electrical energy. The system uses a mechanical arrangement along with an Arduino microcontroller and LCD display to efficiently control the generation and storage of power in a rechargeable battery. It then uses an inverter to convert the stored DC power in the battery to AC power that can run household loads.

Uploaded by

Jayasimha Reddy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
4K views1 page

ARDUINO Based Foot Step Power Generation ABSTRACT

This document describes a footstep power generation system that converts the mechanical energy from walking or running into electrical energy. The system uses a mechanical arrangement along with an Arduino microcontroller and LCD display to efficiently control the generation and storage of power in a rechargeable battery. It then uses an inverter to convert the stored DC power in the battery to AC power that can run household loads.

Uploaded by

Jayasimha Reddy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

Foot step power generation system

ABSTRACT
In this project seminar we are generating electrical power as nonconventional method by simply walking or running on the foot step.

Non-

conventional energy system is very essential at this time to our nation.

Non-

conventional energy using foot step is converting mechanical energy into the
electrical energy. Here in this project a mechanical arrangement is made. Use of
embedded technology makes this system efficient and reliable. Micro controller
(ATMega8 / 168 / 328) allows dynamic and faster control. Liquid crystal display
(LCD) makes the system user-friendly. ARDUINO micro controller is the heart of the
circuit as it controls all the functions.
In this project the conversion of the force energy in to electrical energy. The
control mechanism carries A.C ripples neutralizer, unidirectional current controller
and 12V, 1.3Amp lead acid dc rechargeable battery and an inverter is used to drive
AC/DC loads. The battery is connected to the inverter. This inverter is used to convert
the 12 Volt D.C to the 230 Volt A.C. This 230 Volt A.C voltage is used to activate the
loads. We are using conventional battery charging unit also for giving supply to the
circuitry. Here we are using 16X2 LCD to display the voltage values of the
rechargeable battery using ARDUINO.

You might also like