Scribd
Upload
283 views1 page

Heater Control Valve Removal and Installation

Uploaded by

Michael Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
283 views1 page

Heater Control Valve Removal and Installation

Uploaded by

Michael Hernandez
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

2002 Ford EXPLORER SPORT TRAC

Submodel: | Engine Type: V6 | Liters: 4.0


Fuel Delivery: FI | Fuel: GAS

SECTION 412-02: Heating and Ventilation


REMOVAL AND INSTALLATION

2002 Explorer Sport/Sport Trac Workshop Manual


Procedure revision date: 02/22/2002

Heater Control Valve


Removal and Installation
1.

Prepare the vehicle for heater water control valve assembly (18495) removal.
1.

Drain the engine coolant. For additional information, refer to Section 303-03.

2.

Remove the air cleaner assembly. For additional information, refer to Section 303-12.

2.

Disconnect the vacuum hose and heater hose.

3.

Remove the retaining pins. Position the inner fender well access mat out of the way.

4.

Disconnect the heater hose. Remove the bolt and the heater water control valve assembly.

5.

To install, reverse the removal procedure.


Lubricate the coolant hoses with MERPOL meeting Ford specification ESE-M99B144-B or plain water only, if needed.

You might also like