100% found this document useful (1 vote)
714 views2 pages

New High Performance Regenerative Receiver

Regenerative Receiver for the 80, 40, 20, 17, 15 meters amateurs bands. With 3 transistors NPN and one IC TDA2003 Audio Amp. Author: Olivier Ernst - F5LVG

Uploaded by

rik206
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
100% found this document useful (1 vote)
714 views2 pages

New High Performance Regenerative Receiver

Regenerative Receiver for the 80, 40, 20, 17, 15 meters amateurs bands. With 3 transistors NPN and one IC TDA2003 Audio Amp. Author: Olivier Ernst - F5LVG

Uploaded by

rik206
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

Nouveau

1 de 2

http://oernst.f5lvg.free.fr/rx/1v2-tran-2013/rx-1v1-2013-en.html

New high performance regenerative receiver


Home

I made this regenerative receiver for 5 amateur bands : 80 40 20 17 15m. With this Rx and a home made transmitter, I made several SSB QSO between North America and France. It is possible to listen,
without noticeable detuning, SSB QSO on 15m during 15 minutes. There is no hand effect, no common hum and no mains hum.
I will focus on the following points:
1 RF attenuator, mandatory for all regenerative receiver.
2 Very small coupling capacitor between the antenna, the RF transistor and the tuned circuit to avoid overloading (I use my transmitting antenna).
3 Plug-in coils without coil forms to obtain very high Q. The coils are easy to make : only one coil without tap for each band. I use 4 pins DIN connectors.
4 High C oscillator with NP0 capacitors to obtain a high frequency stability.
5 Band spreading with small capacitors in series with the variable capacitor.
6 High capacitor value between the tuned circuit and the detector to avoid mains hum.
7 Very short connection for the dot and dash lines.
8 Fine tuning with a 1N4007 diode.
9 1N4148 : transistor protection during transmission.
Diameter for the coils : 22mm
80m, L=11 turns, Ct=470pF, Cp=122pF
40m, L=5 turns, Ct=552pF, Cp=55pF
20m, L=3 turns, Ct=320pF, Cp=25pF
17m, L=2 turns, Ct=440pF, Cp=16pF
15m, L=2 turns, Ct=253pF, Cp=16pF
Wire for 80 40m : diameter 0.5mm.
Wire for 20 17 and 15m : 2.5mm2 installation cable.
Good DX, 73

26/01/2016 11:18

Nouveau

2 de 2

http://oernst.f5lvg.free.fr/rx/1v2-tran-2013/rx-1v1-2013-en.html

Olivier Ernst
F5LVG
01-2014

26/01/2016 11:18

You might also like