Scribd
Upload
972 views6 pages

Hyper Terminal User Manual

This document provides step-by-step instructions for setting up a Hyper Terminal connection to communicate with an X8 device via RS232. It details selecting the COM port, setting the baud rate and communication parameters, and verifying the connection by sending a command and receiving a response.

Uploaded by

HaKa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
972 views6 pages

Hyper Terminal User Manual

This document provides step-by-step instructions for setting up a Hyper Terminal connection to communicate with an X8 device via RS232. It details selecting the COM port, setting the baud rate and communication parameters, and verifying the connection by sending a command and receiving a response.

Uploaded by

HaKa
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 6

Hyper Terminal Setup Manual

Step 1:
Please click Start -> Programs -> Accessories -> Communications -> Hyper
Terminal, please refer to the following figure (based on the Windows 2000
Professional Operating System):

The following figure appears:

Step 2:
Please give any name to it such as X8 in the following example, then click [OK]:

Step 3:
Please select the appropriate COM port number which connects to the X8 by RS232
cable then click [OK]. Please refer to the following figure:

Step 4:
Please setup the parameters as the following:
Bits per second: 57600bps (default setting of X8 RS232 connector)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None

Then click [OK] button, it will bring the screen back to the main screen of Hyper
Terminal as following figure, the connection status
displayed on the lower-left corner

will be

Step 5:
Please click the Properties on the toolbar menu.

The following dialog appears:

Please click Settings tab, the following dialog appears:

Please click the [ASCII Setup] then the following dialog appears:

Please check the check box of Send line ends with line feeds and Echo typed
characters locally then click [OK]. It brings the screen back to the main screen.

Step 6:
Please type the $ST then press [Enter], if the communication has established
correctly, the unit should return the message $ER:=0 , which means that the
communication has been made.

You might also like