0% found this document useful (0 votes)
138 views4 pages

Men'S Pants: Sewing Pants With Simple FLY

Download as pdf or txt
Download as pdf or txt
Download as pdf or txt
You are on page 1/ 4

MENS PANTS

SEWING PANTS WITH SIMPLE FLY

NOTE that the outside of the pants is marked as grey


and the inside of the pants as white on the explanatory
pictures.

FRONT AND BACK PIECE


Sew the tucks in the back piece.

On the front piece sew zigzag stitch over the edges of both
aps (separately, not together) and using a removable pencil or dress makers chalk, mark
the curve on the front of the left hand side.

SEW LEGS
Line up the
sides of front and back pieces, right sides
facing in, and sew side leg seam. Do this for
both legs. Line up the inside leg sides and
sew together. Press seam open. Do this for
both legs.

Leave one leg with wrong sides facing out, and turn the other
leg so that the right sides are facing out. Put the right side out
leg into the other leg, lining up the crotch seam.

SEW FLY
With legs lined up inside each other,
sew the front crotch.
Then by
pressing the seam, and following the line,
press and HAND stitch the aps so that
the left side overlaps the right side.
Turn the pants to the
outside and attach the
zip on the right side.
Then, close the overlapping aps
and pin together.
Turn the pants to the inside and carefully open the
aps (you should have the remaining unattached
ap to the left side with zip pinned to its top). Make
sure you do not dislodge the pins on the outside. Attach the zip to the
SINGLE layer of the left ap.
The zip is now attached to the right side of the front
piece (including right ap) and the left ap of the y.
2

Turn pants to the outside again and


overstitch the curved line to join the
aps and give the y its style.
Finally, nish sewing the back seam of the crotch.

Fold and press as shown

WAISTBAND

Attach the unfolded side (B)


edge to the top of the pants,
right sides of the fabric facing each other. Make sure
that the 5 cm overlap is on
the left side. Stitch on.
Fold up the waistband and press seams up towards the waistband.
Fold waistband right sides together and sew edges.

Then turn right side out and press well, being sure to pull
out the corners. NOTE! Corners are shown cut in the picture but you should cut the corners
AFTER you have sewn the edge. Top stitch over waistband, joining it totally to the pants.

CUFFS

a) Fold up a small edge of around 1 cm and press.


b) Fold up a larger edge, of around 1,5-2 cm, press and sew.

The sewing instructions for the mens pants pattern include:


instructions for cutting out pattern,
sewing pants with a simple y,
sewing pants with a complicated y,
sewing pants with extra long y,
adapting pattern and sew pockets.

You might also like