100% found this document useful (2 votes)
762 views5 pages

How To Check Transport With Ping Continous From RBS3000 6000

This document provides instructions for pinging a router from an RBS6000 or RBS3000 using moshell: 1. Find the IP address of the router and hostFroId using MO commands like get IpInterface and fro IpAccessHostEt. 2. Use the EtHostMo_startPing command with the router IP address, hostFroId, number of pings, and packet size as parameters. 3. The output will display ping response times for each packet sent to the router.

Uploaded by

goes_1020038674
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
100% found this document useful (2 votes)
762 views5 pages

How To Check Transport With Ping Continous From RBS3000 6000

This document provides instructions for pinging a router from an RBS6000 or RBS3000 using moshell: 1. Find the IP address of the router and hostFroId using MO commands like get IpInterface and fro IpAccessHostEt. 2. Use the EtHostMo_startPing command with the router IP address, hostFroId, number of pings, and packet size as parameters. 3. The output will display ping response times for each packet sent to the router.

Uploaded by

goes_1020038674
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 5

================================================================================

==
How to ping Router from RBS6000 (Iub Over IP), with moshell 9.0_, NodeB S/W W10B
.
================================================================================
==
Please find below the step by step.
EtHostMo_startPing -d <destIpAddr> -h <hostFroId> -c <noPings> -s <pktSize>
1. Find IP Router destination we want to ping. <destIpAddr>.
MDN220W_Tanjung_Gusta> get IpInterface=1
================================================================================
=================================
82
Equipment=1,Subrack=1,Slot=1,PlugInUnit=1,E
xchangeTerminalIp=1,GigaBitEthernet=1,IpInterface=1
================================================================================
=================================
IpInterfaceId
1
accessControlListRef
availabilityStatus
0 (NO_STATUS)
defaultRouter0
10.160.145.xxx
defaultRouter0State
1 (ENABLED)
defaultRouter1
0.0.0.0
defaultRouter1State
0 (DISABLED)
defaultRouter2
0.0.0.0
defaultRouter2State
0 (DISABLED)
defaultRouterPingInterval
4
defaultRouterTraffic
0 (TRAFFIC_DEF_ROUTER_0)
froId
1
logging
1 (ENABLED)
maxNoOfFailedPings
2
maxWaitForPingReply
3
mtu
1444
networkPrefixLength
27
noOfPingsBeforeOk
2
operationalState
1 (ENABLED)
ownIpAddressActive
0.0.0.0
ownIpAddressPassive
0.0.0.0
reservedBy
[1] =
>>> reservedBy = IpSystem=1,IpAccessHostEt=1
rps
false
subnet
10.160.145.yyy
switchBackTimer
180
trafficType
0 (NOT_USED)
userLabel
vLan
true
vid
104
vlanRef
================================================================================
=================================
Total: 1 MOs
Router: 10.160.145.xxx

3. Find the <hostFroId>


MDN220W_Tanjung_Gusta> fro IpAccessHostEt
================================================================================
=================================
MO
Attribute
Value
================================================================================
=================================
IpAccessHostEt=1
ipacHostEtFroId 1
================================================================================
=================================
Total: 1 MOs
or:
MDN220W_Tanjung_Gusta> stip
================================================================================
=======================================
ET
Host MOName Lnh
Ntp Fro HostIp
Vid HIRP IpAcces
sHostPool/IpAccessSctp
================================================================================
=======================================
DUW2001 Et=1-01-1 1
000100 1
10.160.145.zzz 104 11-1 1-01
================================================================================
=======================================
Total: 1 MOs

4. Direct put command moshell


eMDN220W_Tanjung_Gusta> EtHostMo_startPing -d 10.142.0.xxx -h 1 -c 10 -s 1472
$ EtHostMo_startPing -d 10.142.0.xxx -h 1 -c 10 -s 1472
$ (10.160.145.) received echo reply from (10.142.0.xxx). icmpSeq=0 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=1 time=18 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=2 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=3 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=4 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=5 time=18 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=6 time=18 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=7 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=8 time=19 ms
(10.160.145.zzz) received echo reply from (10.142.0.xxx). icmpSeq=9 time=19 ms
----- 10.160.145.zzz PING statistics ----10 packets transmitted from (10.160.145.zzz) to (10.142.0.xxx).
Packets received/timed-out: 10/0 (Packet loss 0%)
round-trip (ms) min/avg/max: 18/18/19
$
EtHostMo_startPing -d 10.130.68.30 -h 1 -c 20 -s 1472
======================================================

How to ping Router from RBS3000 (Iub Over IP), with moshell 9.0_, NodeB S/W W10B
.
=======================================================
Please find below the step by step.
EtHostMo_startPing -d <destIpAddr> -h <hostFroId> -c <noPings> -s <pktSize>
1. Find where the ETMFX Board
MDN858W_Kapt_Sumarsono> cab
================================================================================
====================================
SMN APN BOARD
FAULT OPER MAINT PRODUCTNUMBER REV
SERIAL
DATE
TEMP COREMGR
================================================================================
====================================
0 1 CBU1
OFF
ON
16HZ
ROJ1192209/1 R5J
CB4E013325 201008
17 +66C *
0 2 ET-MFX
OFF
ON
OFF
ROJ1192315/2 R1A
TU8GK62726 201005
10
0 4 RAX12
OFF
ON
16HZ
ROJ1192187/7 R1B
AE53044192 200607
04
0 5 RAX12
OFF
ON
16HZ
ROJ1192187/7 R1C
TU8G603492 200811
15
0 6 RAX
OFF
ON
16HZ
ROJ1192187/14 R1E
TD3H108599 201112
03
0 7 RAX
OFF
ON
16HZ
ROJ1192187/14 R1E
TD3H181122 201202
24
0 10 TX6HS-04 OFF
ON
16HZ
ROJ1192254/8 R1E
TD3H059373 201110
18
0 11 TX6HS-04 OFF
ON
16HZ
ROJ1192254/8 R1D
B118031922 201101
01
0 12 OBIF
OFF
ON
16HZ
ROJ1192238/23 R1G
B117463613 201008
20
------------------------------------------------------------------------------------------------------------------ETMFX Board: 000200
2. Find IP Router destination we want to ping. <destIpAddr>.
MDN858W_Kapt_Sumarsono> get IpInterface=1
================================================================================
=================================
65
Equipment=1,Subrack=1,Slot=2,PlugInUnit=1,E
xchangeTerminalIp=1,InternalEthernetPort=1,IpInterface=1
================================================================================
=================================
IpInterfaceId
1
accessControlListRef
availabilityStatus
0 (NO_STATUS)
defaultRouter0
10.165.161.xxx
defaultRouter0State
1 (ENABLED)
defaultRouter1
0.0.0.0
defaultRouter1State
1 (ENABLED)
defaultRouter2
0.0.0.0
defaultRouter2State
1 (ENABLED)
defaultRouterPingInterval
4

defaultRouterTraffic
0 (TRAFFIC_DEF_ROUTER_0)
froId
3
logging
1 (ENABLED)
maxNoOfFailedPings
2
maxWaitForPingReply
3
mtu
1500
networkPrefixLength
27
noOfPingsBeforeOk
2
operationalState
1 (ENABLED)
ownIpAddressActive
0.0.0.0
ownIpAddressPassive
0.0.0.0
reservedBy
[1] =
>>> reservedBy = IpSystem=1,IpAccessHostEt=1
rps
false
subnet
10.165.161.yy
switchBackTimer
180
trafficType
0 (NOT_USED)
userLabel
vLan
true
vid
408
vlanRef
================================================================================
=================================
Total: 1 MOs
Router: 10.165.161.xxx
3. Find the <hostFroId>
MDN858W_Kapt_Sumarsono> fro IpAccessHostEt
================================================================================
=================================
MO
Attribute
Value
================================================================================
=================================
IpAccessHostEt=1
ipacHostEtFroId 1
================================================================================
=================================
Total: 1 MOs
or:
MDN858W_Kapt_Sumarsono> stip
================================================================================
=======================================
ET
Host MOName Lnh
Ntp Fro HostIp
Vid HIRP IpAccessHo
stPool/IpAccessSctp
================================================================================
=======================================
MFX11 Et=1-02-1 1
000200 1
10.165.161.zzz 408 11-1 1-01
================================================================================
=======================================
Total: 1 MOs

4. Command moshell

MDN858W_Kapt_Sumarsono> lhsh 000200 ; EtHostMo_startPing -d 10.165.161.xxx -h 1


-c 5 -s 1472
$ lhsh 000200
Welcome to OSE Shell ose5.4.
000200> EtHostMo_startPing -d 10.165.161.94 -h 1 -c 5 -s 1472
000200> (10.165.161.zzz) received echo reply from (10.165.161.xxx). icmpSeq=0 ti
me=9 ms
(10.165.161.zzz) received echo reply from (10.165.161.xxx). icmpSeq=1 time=8 ms
(10.165.161.zzz) received echo reply from (10.165.161.xxx). icmpSeq=2 time=8 ms
(10.165.161.zzz) received echo reply from (10.165.161.xxx). icmpSeq=3 time=8 ms
(10.165.161.zzz) received echo reply from (10.165.161.xxx). icmpSeq=4 time=8 ms
----- 10.165.161.zzz PING statistics ----5 packets transmitted from (10.165.161.zzz) to (10.165.161.xxx).
Packets received/timed-out: 5/0 (Packet loss 0%)
round-trip (ms) min/avg/max: 8/8/9
000200> exit
$

You might also like