Scribd
Upload
52 views5 pages

Saxena, Ankur: From: Sent: To: Subject

The document outlines several changes that need to be implemented in two models, C85 and C86. It describes updates to the bridge carrying the cooling system, changes to sidewall profiles and holes, modifications to profiles on the right side, a detail change in a gray area, and changing the foot that carries the engine bracket along with holes in the sidewall in that region. The engineering drawings and locations for the changes are provided.

Uploaded by

Ankur Saxena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
52 views5 pages

Saxena, Ankur: From: Sent: To: Subject

The document outlines several changes that need to be implemented in two models, C85 and C86. It describes updates to the bridge carrying the cooling system, changes to sidewall profiles and holes, modifications to profiles on the right side, a detail change in a gray area, and changing the foot that carries the engine bracket along with holes in the sidewall in that region. The engineering drawings and locations for the changes are provided.

Uploaded by

Ankur Saxena
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 5

Saxena, Ankur

From:
Sent:
To:
Subject:

Steiner, Jens
Wednesday, January 06, 2016 8:30 PM
Saxena, Ankur
Please forward to Sathiish

Hello Sathiish!
I just got to know about some changes that we have to implement into the two models C85 and C86.
First, the Bridge that carries the cooling system has to be updated. The picture on the right side shows the latest version.
The geometry can be found here: I:\engineering-service\CSE-FEM\FEM_ES\01_Projects\FY2016\Assembly_C85\Bridge_Cooling_System.hm
I:\engineering-service\CSE-FEM\FEM_ES\01_Projects\FY2016\Assembly_C85\ Seperation_Housing_C86_C85.hm

Further on, there are a couple of changes on the sidewalls:


The two red marked holes on the left picture can be deleted, the latest version is the picture on the right side. The red profiles on the right picture are new, the small green
marked profile on the left can be deleted.

Further changes are on the right side:


The two blue marked profile on the left can replaced by the profiles shown on the right.
The purple marked profile has to be shifted upwards.
The yellow marked profile has to be modified. It has got a greater width on the right picture.

There is a small detail in the grey marked area:

And finally, the foot that carries the engine bracket has to be changed. The holes in the side wall in that region have to be changed, too.
3

These change have to be implanted to both models, C85 and C86. Im sorry if its double work, but the information is brand new.
In case of any questions, please give me a call.

Best regards

Jens

Mit freundlichen Gren


______________________________________
Jens Steiner
CLAAS Selbstfahrende Erntemaschinen GmbH
CSE Virtuelle Funktionsauslegung
Muensterstr. 33
33428 Harsewinkel
Germany
4

Phone +49 5247 12-2071


Fax +49 5247 12-2307
mailto: [email protected]
http://www.claas.com

You might also like