Scribd
Upload
63 views2 pages

AMffucu

This document contains instructions for solving several circuit analysis problems: determining line regulation percentages for a voltage regulator circuit; calculating minimum input voltage for a full-wave rectifier; finding output ripple percentages for an RC filter circuit; determining load current through an RC filter; and calculating maximum load current while maintaining regulation. It also includes plotting an output waveform.

Uploaded by

Ted Anthony
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
63 views2 pages

AMffucu

This document contains instructions for solving several circuit analysis problems: determining line regulation percentages for a voltage regulator circuit; calculating minimum input voltage for a full-wave rectifier; finding output ripple percentages for an RC filter circuit; determining load current through an RC filter; and calculating maximum load current while maintaining regulation. It also includes plotting an output waveform.

Uploaded by

Ted Anthony
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

1.

Determine Vo and Vdc

2. The input of a certain regulator increases by 3.5 V. As a result, the output


voltage increases by 0.042 V. The nominal output is 20 V. Determine the line
regulation in both % and in %/V.
3. Calculate the minimum input voltage of the full-wave rectifier and filter
capacitor network

4. An RC filter stage (R = 33 , C = 120 mF) is used to filter a signal of 24 V


dc with 2 V rms operating from a full-wave rectifier. Calculate the percentage
ripple at the output of the RC section for a 100-mA load. Also calculate the
ripple of the filtered signal applied to the RC stage.
5. . A simple capacitor filter has an input of 40 V dc. If this voltage is fed
through an RC filter section (R = 50 ohm, C = 40 mF), what is the load
current for a load resistance of 500 ohm
6. Determine the maximum value of load current at which regulation is
maintained for the circuit

7. Plot the output waveform

You might also like