Scribd
Upload
49 views2 pages

Cv. Tekno Asri: Electronic Load Controller (ELC)

This document provides technical specifications for an electronic load controller (ELC) and a balast load. The ELC can operate at voltages of 220/380V or 230/400V, as a single or three phase unit, at frequencies between 47.5-52.5 Hz or 57.5-62.5 Hz with a power output of 5 kW and recovery time of 10 milliseconds. It provides protection from short circuits, overloads, over voltage and over frequency. Standard metering includes voltage, frequency, operation hours and amperage. Specifications are also given for a 5kW tubular air heater balast load made of metal and ceramic materials.

Uploaded by

Anonymous 7M3tl2WOns
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
49 views2 pages

Cv. Tekno Asri: Electronic Load Controller (ELC)

This document provides technical specifications for an electronic load controller (ELC) and a balast load. The ELC can operate at voltages of 220/380V or 230/400V, as a single or three phase unit, at frequencies between 47.5-52.5 Hz or 57.5-62.5 Hz with a power output of 5 kW and recovery time of 10 milliseconds. It provides protection from short circuits, overloads, over voltage and over frequency. Standard metering includes voltage, frequency, operation hours and amperage. Specifications are also given for a 5kW tubular air heater balast load made of metal and ceramic materials.

Uploaded by

Anonymous 7M3tl2WOns
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 2

CV.

TEKNO ASRI
Jl. Merah Delima 2, Komplek Bandung Indah Raya B1-22, Bandung
Tel./Fax. 022-753 6040 E-mail: [email protected]

Electronic load controller (ELC)


-

Technical Specifications :
Rated voltage : 220/380 V or 230/400V
Phase : 1 or 3 phase
Rated frequency : 50 / 60 Hz
Frequency range : 47.5-52.5 Hz / 57.5-62.5 Hz
Power output : 5 kW
Recovery time : 10 millisecond
Basic protection : short circuit and overload on consumer, over
frequency/voltage
Generator type : Synchronous with or without AVR (brushesless and
brushes)
Standard metering :
Generator voltage 1P (Volt)
Generator frequency 1P (Hz)
Hour meter to record the operation of system (h)
Ampere meter for consumer 3P (Amp)
Ampere meter for ballast load 3P (Amp)
Pilot lamp on each phase 3P

CV. TEKNO ASRI


Jl. Merah Delima 2, Komplek Bandung Indah Raya B1-22, Bandung
Tel./Fax. 022-753 6040 E-mail: [email protected]

Balast Load
Tubular air heater industrial standard, capacity power 5KW, material metal, ceramic

You might also like